Re: [TowerTalk] Cadwelding ground rods

[Jim W7RY <w7ry@centurytel.net>]

Bend the top vertical with a piece of pipe.

Not sure if you can get the weld material level in the mold or not. Best 
if the mold can be level or you will end up with a bad weld.
73
Jim W7RY

On 1/1/2014 9:22 AM, Mike Fahmie wrote:
> How close to vertical must Cadweld One Shots be?  I'd like to drive some ground 
> rods diagonally into the sides of my tower foundation hole but am concerned 
> that the One Shots might not function properly on a non-vertical rod.
>
>
> -Mike-
> WA6ZTY
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk