I had a chance to pick up some of the old style Philly without ends. This
stuff needs to have "potted" ends. Plan on spending at least $35 for each
"empty" end and at least $70 for the resin potting compound. You will
find the cost is prohibitive unless you are pouring a dozen or so ends, since
the potting mix has to mixed all at once.
The factory can give you the details.
Bill K4XS/KH7XS
In a message dated 2/26/2014 2:38:46 A.M. Coordinated Universal Time,
Gunsrus1942@Comcast.net writes:
I'm going to be using Phillystran Cable .22 size and am not able to use
the "Big Grip" on a couple of the ends & was wondering if a standard
"guy wire clamp" can be used and what is the recommended configuration?
It appears that DX Engr. recommends that guy wire clamps only be used on
.17 and smaller.
Thanks for your input.
73, Tom W1ALZ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|