Towertalk
[Top] [All Lists]

Re: [TowerTalk] RTV

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] RTV
From: "Ian White" <gm3sek@ifwtech.co.uk>
Date: Fri, 7 Nov 2014 08:56:44 -0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Yet another good alternative is hot melt glue. HMG forms a flexible,
weatherproof seal onto metals, plastics and many other kinds of
materials. In many years of outdoor use, in a notoriously wet climate, I
have never had a single failure with HMG. 

Grey translucent HMG is a form of polypropylene, which means it is
chemically inert and also an excellent RF insulator. Anywhere you see
polyethylene (a close chemical relative) you can also use HMG. I have
used it routinely for sealing the exposed ends of coax 'tails' and for
blocking the open ends of semi-airspaced cables - once again, with no
failures at any frequency or power level.

The only precautions about using HMG are temperature-related. Cold metal
surfaces may need some pre-heating to avoid chilling the glue on
contact, which would cause a poor bond; and of course HMG will soften if
the surface becomes too warm. For very warm conditions, I'd go with
Chuck and use a solvent-based "High Strength Clear Adhesive", our local
equivalent of "Goop".


73 from Ian GM3SEK


>-----Original Message-----
>From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
>Chuck Smallhouse
>Sent: 07 November 2014 02:50
>To: towertalk@contesting.com
>Subject: [TowerTalk] RTV
>
>The best all around RTV, or when used as for gluing components, is
>GOOP.  It's available everywhere, including grocery stores.  It
>originally started(over 30 years ago) out as being used for repairing
>soles of "Tennis" shoes.  They market it in several different
>varieties for various uses.  I can't tell any difference between them
>so buy the cheapest variety.  Most all dry clear.
>
>It will be good for RTV for filing the backshells of your rotator
>connectors.  It's somewhat flexible and can be quite easily removed
>when you want to take something apart.  The residue can be rubbed off
>with your fingers afterwards.  I use it also to glue components as
>big a sealed relays, and OCXOs, for holding them down onto a chassis,
>deadbug style.  It's much stronger than Super Glue.  To glue
>something together or down, it's best to apply pressure until its
>cured/dried.
>
>To increase its shelf life, after opening a tube, it seems to be
>better kept in sealed container, like an empty instant coffee jar,
>even when its cap is put securely back on.
>
>Chuck,  W7CS
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>