How about maybe in a underground nuclear test bore hole, it would deliver the
signal before the coax melted entirely (?).-Mike-
From: Jim Lux <jimlux@earthlink.net>
To: towertalk@contesting.com
Sent: Saturday, November 29, 2014 4:37 PM
Subject: Re: [TowerTalk] Coax loss. Has anybody measured it ?
On 11/29/14, 10:36 AM, David Robbins wrote:
> You want some lossy coax? I have a couple old rolls where both the center
> conductor and shield are nichrome. VERY lossy stuff!
>
What would they use nichrome coax for? Some sort of test jig for heating?
For use in a refractory or corrosive environment? I think I've seen
hastelloy or something other superalloy.
I've seen stainless steel coax for cryogenic applications (very low
thermal conductivity going in and out of a dewar), but it had a thin
silver plating. For microwave frequencies, the plating was thicker than
skin depth.
I've also seen delay line coax, where the center conductor is a tight
helix: the inductance/unit length is high so the propagation speed is
slow (and the Z is high, too). That stuff was quite lossy, although not
in a "dB/wavelength" sense.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|