Towertalk
[Top] [All Lists]

Re: [TowerTalk] adding insulators to guy wires

To: "va6zzz@mcsnet.ca" <va6zzz@mcsnet.ca>, Towertalk Reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] adding insulators to guy wires
From: Jim Hoge <knowkode@verizon.net>
Reply-to: Jim Hoge <knowkode@verizon.net>
Date: Sat, 9 May 2015 14:08:35 +0000 (UTC)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I agree that chicago grips are necessary tools for tower work, right after gin 
poles and tower jacks. However, guy wires are most often broken up into non 
resonant sections by multiple insulators. If you were only going to add an 
insulator near the bottom of the guy then yes, your method works. If you have 
multiple insulators on each guy then they will be out of reach, necessitating 
the dropping of the guy for retrofitting.
My preferred method is to not reuse guy wire. I will not reuse cable clamps, 
ever. New material and hardware is inexpensive compared to a complete tower and 
I view it as cheap insurance. Before I begin replacement, I will ensure that 
the old guys are properly tensioned and the tower is plumb. Then, I begin by 
replacing one guy at a time. I do not drop the old guy until I have attached 
the new one at the tower. I then remove the old one at the guy anchor and 
install the new one. By doing only one at a time, I have found it easier to 
ballpark the new guys and keep the tower plumb. Oh, and I always start with the 
bottom set of guys, just like I was building a new tower. Yeah, my method is 
time consuming but it can be accomplished solo but having a helper on the 
ground speeds things up and provided he too can climb, adds a necessary safety 
factor to the work.
gl es stay safe,Jim W5QM 


     On Saturday, May 9, 2015 7:41 AM, "va6zzz@mcsnet.ca" <va6zzz@mcsnet.ca> 
wrote:
   

 Folks, the way to add insulators to existing guy wires is really quite 
simple...you need  a"chicago grip" and a come-along...these tools allow 
the guy to be cut while still maintaining wire tension.  There is no 
need to add temporary guy wires. These tools are used daily in the power 
line and commercial tower industry.
73...Gerard VE6ZZZ
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


  
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>