I have a 380 foot coax run to the top section of my motorized tower when it is
fully extended.
I am changing out all my old RG213 and thinking of saving a few db by going to
LMR600 up to the top section then
LMR400UF up from there for the rotor loop and up to the 40 meter beam and
triband/warc beam on the mast.
What do you think of LMR600 for this run from the shack up to the top section
for a motorized tower ?
When I lower the tower I am thinking I could coil the LMR600 into maybe 5 foot
diameter coils on the ground.
BTW the tower is 90 feet to the top of the top section when all the way up.
Is this a bad idea ? (I am hoping to avoid the cost of the flex LMR600UF if I
can.)
A side issue is I understand I have to be very careful not to nick the copper
clad on the center conductor
when installing a connector on the non flex LMR600. I would use the Davis
PL259 connectors for LMR600. Anyway maybe this usage of the
LMR600 is not a good idea, what do you think ?
Bob
K6UJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|