Towertalk
[Top] [All Lists]

Re: [TowerTalk] ground radials

To: towertalk@contesting.com
Subject: Re: [TowerTalk] ground radials
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
Date: Sun, 21 Feb 2016 15:15:31 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
It will work fine, but depending on the soil and the type of rain you get, it will rust, fast, or slow, but will eventually need replacing. Around here (central Mi) the soil would quite corrosive, but where I was raised was a low hill of quality sand. Where I am now is right on the edge of a abt 100 acres of woods with a pear base,That base extends under some of my yard, So the plated steel would be a poor choice for me.

To me the multi conductor as suggested by, I believe N8de would work well. When I was asking around while doing some networking, I was given three partial, 1000 ft boxes of CAT5, The total of which was well over 1000 feet. The jacket was not UV resistant and failed quite soon. but those tiny wires hold up well, but it is mechanically fragile. A cat 5 cable has 8 #22, (some even smaller) solid, or stranded wires. Both are available. The solid breaks easily.

One post referred to installing radials as difficult. It doesn't have to bee, but it likely will time consuming

There have been several posts in the past of devices that cur the soil and planted the radial

73,

Roger (K8RI)


On 2/19/2016 Friday 12:24 PM, w5jmw@towerfarm.net wrote:
is galvanized fence wire ok for ground radials? thanks
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


--

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>