Towertalk
[Top] [All Lists]

Re: [TowerTalk] Datasheet for Rohn TA-55

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Datasheet for Rohn TA-55
From: <john@kk9a.com>
Date: Fri, 6 Jan 2017 17:57:30 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I star guy my Rohn 55g and Rohn 65g towers.  Before adding the torque
assembly my Rohn 65 it did noticeably twist when rotating my 60' boom
antenna (this was prior to owning Green Heron controllers with a ramp) and
also twisted somewhat in the wind. It did not twist a damaging amount
however there is no harm to having a star guy. I also thought about what
happens with rotating towers. Certainly a 200 Rohn 45 or 55g must twist
considerably. I remember when K4JA's rotating AB105 tower started twisting
back and forth in heavy wind before breaking apart. I would assume that a
star guyed tower is less susceptible to destructive harmonic oscillation.

John KK9A


To:     <towertalk@contesting.com>
Subject:        [TowerTalk] Datasheet for Rohn TA-55
From:   "Jim Thomson" <jim.thom@telus.net>
Date:   Fri, 6 Jan 2017 09:32:18 -0800

##  heres the part that I dont get.   The 6 point guy system will reduce on
the 
tower
where the..cue rack is installed... almost down to nothing.   Is torque even
an 
issue ? 

##  these rotating towers  all use rings..and the typ 3 guy wires per
ring..are 
attached  to the
ring.... not to the tower.   IE:   There is nothing to stop the tower from 
torquing at all ! 
The guy wires on the rotating towers just hold up and support the tower,
they 
dont provide
any torque redux  at all.     Then folks install 188-220 ft tall rotating
tower 
assys... with the
usual myriad of large HF yagis on them, typ with a 80m yagi  at the very
top. 

##  meanwhile the rotor is at the very bottom, like on the K0XG setups.
The 
tower appears
to me to be one big.... mother of all torque wrenches.  The myriad of yagis
are 
all bolted to
the same tower face too.  How much to these rotating towers actually twist
in 
high winds ??? 

##  If twist is a non issue on a rotating tower, then why even mess with the

...cue-rack..aka 
rohn TA55  assy at all ??   What am I missing here ? 

Jim   VE7RF
_____________

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>