Hi John,
In my initial posting I forgot to mention the reason for my concern. The
north leg of the dipole is supported on the west end of my house at two
points. A tree limb falling on the south leg of the dipole would damage
those two supports, the areas of the house where the supports are
attached, the ridge vent and perhaps shingles. So my goal is not
protecting the antenna wire, but, rather, the north supports and roof of
the house.
Some web sites I've looked at say the tensile strength of #14AWG
stranded copper wire is around 130 pounds. So my thinking is to insert a
short length of something much weaker at the south end between the
insulator and the support rope.
This is new ground for me, so advice and ideas are appreciated. What
should the "something much weaker" be? Rope? Fishing line? Other? What
should its breaking point be in order to avoid nuisance breaks but still
protect the stuff at the north end of the antenna?
Steve, K8JQ
On 6/24/2017 10:04 AM, john@kk9a.com wrote:
What is your concern? I use the same wire for temporary Beverage antennas
and twice in the last 10 years I had tree branches fall and break the wire.
It is easy to splice the THHN back together.
John KK9A
To: TowerTalk <towertalk@contesting.com>
Subject: [TowerTalk] Mechanical weak link in leg of dipole
From: Steve65 <steve65@suddenlink.net>
Date: Fri, 23 Jun 2017 15:38:31 -0400
List-post: <mailto:towertalk@contesting.com>
Hello all,
The south end of my 80-meter dipole runs among trees. The trees are higher
than the antenna wire and have limbs which are above the dipole. Big limbs.
The dipole is made of #14AWG THHN. It is supported at its southern end with
about 40ft of 3/16in rope tied off in a tree.
One of the trees that is near the antenna is a large beech. One of its limbs
broke off a few months ago and narrowly missed the antenna wire. I'm
thinking about installing a mechanical weak link in this leg of the dipole
that would break if one of the heavy limbs falls across the antenna wire.
Good idea? Bad idea?
What material would be a good choice for the weak link?
Thanks.
Steve, K8JQ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|