Good afternoon,
I have an older crank-up tower made by the predecessor to U.S. Tower.
The rotor plate for that tower sat on the horizontal cross braces and had a
small lip that stuck down about 1/2 inch on the inside of the cross braces
to hold the plate in place.
I just purchased a new rotor plate from U.S. Tower and it is different. It
fits inside the cross braces. Also there are two small holes located at
each corner.
Could someone who has a new U.S. Tower tell me how this is supposed to
mount?
Thank you all very much.
Howard, WA9YBW
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|