Do not remove the galvanization. Just put some layer of Vaseline or some other
gunk that wouldn't come off. You can even use paint. Wrap you shim around it
while the paint is still wet, clamp it with you SS clamp and you should be all
set.
The pressure of the clamp through the thin shim will cause high pressure
spot-wise. That will penetrate the paint layer and cause the electric contact.
The contact spots will be surrounded by a, hopefulle, water tight layer of
gunk, which will reduce the corrosion.
I have an aluminum tower myself and aluminum wires for the ground connection
which reduce the corrosion possibility.
Hans - N2JFS
-----Original Message-----
From: Jeff Blaine <jeff@ac0c.com>
To: towertalk <towertalk@contesting.com>
Sent: Sun, 15 Oct 2017 9:15
Subject: [TowerTalk] Grounding connection to tower legs
What’s the best way to connect the copper wire/strap to the 55G tower leg?
I’m planning to clean the galvanized leg, wrap the leg with a layer of 0.005”
SS shim stock and then use a couple of SS hose clamps to hold the wire against
the tower leg.
Is that the right way to do the attachment?
Should I use any copper paste as well?
73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|