Am I correct that the two ends are the leg diameters not the swaged
diameters? If so, a simple anything steel solid rod turned to the leg
id of 1.125" minus 0.005" clearance (1.120") and drilled for the bolts
will join the sections.
Grant KZ1W
On 2/18/2018 11:22 AM, Herbert Schoenbohm wrote:
Amazing but my tower erector put the last section of Rohn 25G with the
gender wrong and coupled with a special adapter to Rohn 45 below. Now I
am trying to put up a Rohn 25G top section but the genders are the same
size. Duh. It would a major project to flip the wrong gender Rohn 25G
around. So I am wondering if a set of (3) coupling sleeves are available
anywhere. I check both the Amerite and the Rohn catalog but came up empty.
These sleeves would be the same size as the diameter of a base plate.
But welding two base plates or bolting them together is a way out but
expensive. Any suggestions would be appreciated.
Herb Schoenbohm, KV4FZ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|