I seem to remember you having to set the CDE parameter to "off" in the radio
menu.
Jan
G0iVZ
-----Original Message-----
From: Dale L Martin <kg5u@hal-pc.org>
To: TRLog Reflector <trlog@contesting.com>
Date: 02 October 2001 05:47
Subject: [TRLog] RE: Omni VI Setup
>
>
>> Hi to all,
>>
>> I'm having problems interfacing TRLog to an TEN-TEC OMNI VI using the
>> following configuration:
>>
>> RADIO ONE TYPE = IC735
>> RADIO ONE CONTROL PORT = SERIAL 2
>> RADIO ONE NAME = OMNI
>> RADIO ONE BAUD RATE = 1200
>> RECEIVER ADDRESS = 04
>>
>> I've checked that the OMNI VI is running 1200 baud and is on address 04,
>> serial port is no. 2 and cable is also ok. What else could I have
>> missed??
>>
>> Thanks for any help
>>
>> Stefan, DL7AOS
>>
>
>
>I can't see anything wrong and I have two Omni VI's.
>
>You HAVE tried 2400 baud, right?
>
>Here's a piece of my .cfg:
>
>Radio one control port = serial 1
>Radio one baud rate = 2400
>Radio one name = Radio 1
>Radio one type = ic735
>
>Radio two control port = serial 2
>Radio two baud rate = 2400
>Radio two name = Radio 2
>Radio two type = ic735
>
>I suggest you go back to your serial cable.
>
>If you are using a db25 to db25 cable, make sure your using this wiring
>config:
>Omni PC
>pin pin
>2 2
>3 3
>7 7
>
>The following pin listing is very important. Some versions of the Omni VI
>manual db25 to db9 cable wiring diagram were wrong!
>
>db25 to db9
>Omni PC
>pin pin
>2 3
>3 2
>7 5
>
>Good luck and 73,
>dale, kg5u
>
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/trlog
>Submissions: trlog@contesting.com
>Administrative requests: trlog-REQUEST@contesting.com
>Problems: owner-trlog@contesting.com
>Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
>
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|