Can anyone tell me how to set up, config, install whatever I need to do to
make my byterunner 410H work in DOS?
I am so far outside of my sandbox here
Below is what I copied from the readme file. So now what? Can anyone give
me step by step instructions?
Mainly I need help with the autoexec.bat file stuff. Addressing I can do.
I have run the VSSHOW.exe and am okay there. And I know how to set up TR.
What I don't know how to do is the autoexe.bat stuff.
VSEMUIO should be started before the user application. We suggest to run it
in the AUTOEXEC.BAT file. The program accepts one command line paramater
which gives the name of the configuration file to be used. If omitted the
name vsemuio.cfg in local directory will be assumed.
Syntax:
VSEMUIO
or
VSEMUIO <file name>
Configuration file
VSEMUIO is very sensitive to syntax. Each line describes one port.
For serial ports:
S,<real io>,<virtual io>,<virq>,<clock>,<com number>
< real io> real io address of the port on the VScom card. To find out
what the actual IO addresses of the ports are, run the
program VSSHOW.EXE.
< virtual io> virtual address to be used.
<virq> virtual irq for the port
<clock> Factor by which the clock of VScom card is higher than
standard clock. (This is generally 8)
<com number> the COM number under what the system can access this port.
Example for COM1 and COM2:
S,D400,03f8,4,8,1
S,D408,02f8,3,8,2
Michael WG0M
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|