WriteLog
[Top] [All Lists]

[WriteLog] PK-232

To: <writelog@contesting.com>
Subject: [WriteLog] PK-232
From: k0bx@qsl.net (Joe Duerbusch)
Date: Thu, 1 Mar 2001 01:24:14 -0000
Jim, I believe that you must have your PK-232 at 9600 baud.
PK-232 INTERFACING
A PK-232 may be used for CW keying.  See the documentation of that device
for information on connecting the PK-232 to your computer.  If WriteLog will
not communicate with your PK-232, it may be necessary to do the
editing described below.
Using NotePad edit C:\Windows\writelog.ini  as follows:
In the file, go to the section labeled [Ports].
Look at the line for the Com port you intend to use.  It will look like
this:
COM1:=9600,n,8,1,x
Check to be sure all parameters are correct, then Delete the final x (but
not
the comma).  It should look like this:
COM1:=9600,n,8,1,
Click on File, Save.  Then open WriteLog; this should allow
your PK-232 to communicate with WriteLog.

This works for RTTY also in Writelog.
I have other PK-232 info's at  http://www.qsl.net/k0bx

Good Luck
Joe K0BX



--
WWW:                      http://www.writelog.com/
Submissions:              writelog@contesting.com
Administrative requests:  writelog-REQUEST@contesting.com
Problems:                 owner-writelog@contesting.com


<Prev in Thread] Current Thread [Next in Thread>