I believe the COM1 settings in [PORTS] are applied to COM11 after the
assignment of CommSlot1=11. No need to create a separate line in [PORTS]
that says COM11=4800,N,8,1. Best way to check it out is to fire up WL and
see what happens!
73,
Gary AL9A
----- Original Message -----
From: "Eric Hilding" <b38@hilding.com>
To: <writelog@contesting.com>
Sent: July 28, 2008 6:37 PM
Subject: Re: [WriteLog] Virtual COM Port Assignment in WL .ini ?
> I'm still uncertain how to substitute the CommSlot1=11 statement and
> retain
> the same COM1 settings currently in:
>
>
>
> [PORTS]:
>
> COM1:=4800,N,8,1
>
> <snip>
>
>
>
> In other words, 4800 baud currently follows the '=' sign, but if I use
> CommSlot1=11, does anyone know the format I should use to end up with
> 4800,N,8,1 still in the food chain?
>
>
>
> Tnx very much & 73...
>
>
>
> Rick, K6VVA
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|