After getting Don's message below I decided to uninstall V10.74J and go back
to V10.73D because the WL mixer control worked there last weekend.
Uninstalled 10.74J and installed 10.69D full install. Started it up and
still no audio to the WL mixer control. Did the update to 10.73D - still no
audio making it into the WL mixer control. Updated again back to 10.74J -
still no audio. I think this eliminates the 10.74J update as the culprit.
Obviously I have something else going on here, but am lost as to what.
With WL running, the Line LED on the MKII is lit and the vertical bar in the
Sound Recording tab for the microHAM line CODEC is showing movement.
However, the WL mixer control is not getting any input from the MKII. I now
suspect Vista has once again reared it ugly head, but can't figure out where
to find more info and make a setting change to get things right again. This
is tedious - seems like every time I start WL under Vista it's a crap shoot
as the whether or not the sound card will be allowed to function properly!
73,
Gary AL9A
----- Original Message -----
From: "Don Bergmark" <dbergmark5@q.com>
To: "'Gary AL9A'" <al9a@mtaonline.net>
Sent: January 07, 2010 1:55 PM
Subject: RE: [WriteLog] Audo recording problem
> Hi Gary
>
> I have the same problem. I have been playing around with this for 3 or 4
> days now and am about ready to delete all of Writelog and start over. Let
> me know what the solution is.
>
> Don
> W9NGA
>
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Gary AL9A
> Sent: Thursday, January 07, 2010 2:31 PM
> To: Writelog Reflector
> Subject: [WriteLog] Audo recording problem
>
> I'm checking out my setup for the NAQP CW contest Sat. and notice my WL
> Sound MIxer Level Control is not receiving any signals from the radio.
> I'm
> running a new IC-7600 with a MKII under Vista 32 bit. All the Radio Audio
> settings are correctly set to the proper microHAM CODECs. It worked fine
> last weekend for the RTTY RU and I have made no changes to the cable
> hookups
>
> since then. If I open the Sound window and click on the Recording tab I
> can
>
> see the vertical bar graph bouncing up and down in response to the
> received
> signal, but the vertical bar graph in the WL Mixer control is dead. I can
> find nothing in the Vista Sound window indicating that something is muted.
> The only thing I can think of that is different from last weekend is that
> updated WL itself to V10.74J. Any suggestions appreciated.
>
> 73,
> Gary AL9A
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|