Had same problem, MMTTY lost it FSK config.
Russ, K5OA
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of DickT-W0RAA
Sent: Sunday, June 09, 2013 11:04
To: FT-950 Reflector; Rtty Contesting Reflector; Writelog Reflector
Subject: [RTTY] Question
I am using a Yaesu FT-950 with a SignaLink USB Interface. Up until this
weekend, it has performed flawlessly in RTTY mode. I usuall run PKT | LSB
when running in digital modes and have never had a problem.
Now, I cannot get the 950 to send out a signal when I send a macro using my
Writelog program (latest version). I am not getting any RTTY output using
MMTTY either.
It shows that I am transmitting, but there is no signal going out. Zero
power out. In all other modes I ama getting full
100 watts
power out (SSB/CW, etc).
I have not changed anythinh since the last contest, Might anybody have any
suggestions as to where I should be looking? The problem is only in RTTY
mode.
TIA<
Dick
W0RAA
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|