I am using 4.27 SR-4100's on RG-1000's in Nat mode. I cannot do a traceroute from the ethernet side of one of any of these RG's. It shows the wireless (external) ip and then just gives me * *'s until
I have a php script/webpage that will perform these steps. I don't remember where I found it but it gives all the information that I was looking for. Client name Client MAC SNR Signal Noise etc. Howe
Ok, I'm a newbie at this so bear with me. I'm just playing around with some karlnet gear that I just picked up. I've got a few AP's and a few soho clients. It appears that the soho must be set to the
I've got a 4.02 RG-1000 that absolutely will not bridge to my 3.88 AP-1000. The RG links up and everything appears to be functional but I cannot ping anything...it is as if the RG just isn't passing
Did you disable bridging on the NAT RG's? If you are doing NAT....There should be nothing checked on the left side of the General option on the configurator. Otherwise, your NAT ip's will leak onto y
the private nat addresses on the public side of the RG. It would seem that even if you enabled bridging (while running nat) it would drop the private IP's from the selected interface. -bob
If you are looking for a solution to block a users NAT firewall from using your system....I don't think this is what they are talking about. I believe this feature is just an option to make sure that
Specifically you are asking if one can keep people from doing NAT ? I'm not sure you could really do that......I've heard of ways to detect nating but never really read into it enough to commit it to
The bin or the docs? www.demarctech.com has most of the bins www.cwlab.com has them as well. this procedure. Can someone tell me where to find it please.
Here....I'll give you the skinny.. power on your device (ap/rg) hit the reset button then hold down the forced reload button until JUST the power led is RED. Open the configurator program. Click on "
Are you sure you have the correct MAC? It is the MAC of the Ethernet not the wireless.. the Highlight as you Find it back into forced reload again. WHAT GIVES?
Has anybody really tried to use this app? When doing site surveys with the thing, I've found that the link analysis will freak out. Exactly what happens is I position the antenna until the signal led
Well, I was exaggerating a bit about it being down that much. I would say that 3 of the last 10 times I've been there....(over several weeks) there has been a problem and those three times....I reall
Here is my setup AP-1000 w/ ISP base RG-1000's w/ SOHO Why when I do a link test at a client why do I not only get the access point but adjacent clients? If I choose an adjacent client it looks as if
I think I confused myself on that one.... I should have cleared that up by stating that I'm connecting with the SOHO clients and they are showing adjacent SOHO clients in the "remote link partner" wi