Karlnet Support Can you give us a time frame for the website update of license-it.com for the kn50's? Thanks Dan [mailto:karlnet-bounces@WISPNotes.com] in card what RAM this. firmware of HW is KN50.
A ping fill test is generally over 6Mbps [mailto:karlnet-bounces@WISPNotes.com] saw -- [This E-mail scanned for viruses by Declude Virus] _______________________________________________ Karlnet maili
Brett, What version of knet do you have on the AP's? 4.44? Dan [mailto:karlnet-bounces@WISPNotes.com] past reboot you are (100 - (3-4 happens (KN100) -- [This E-mail scanned for viruses by Declude Vi
across Reg - we have an issue like this as well -- basically we can no longer PING the AP or any networks behind it from the CPE side yet a wireless link test looks very good, this only happens on t
It never happens at night, it happens sometimes 4 times a day, other times it will go for a week without any issues... Its also my largest "AP" with 20 clients on it..... -- [This E-mail scanned for
happens will kn50's If you reboot the CPE, you'll notice the MAC address of the AP doesn't show up in the CPE until everything returns to normal.... Also if you check the AP, everything looks fine -
pretty fill from AP to AP I see 6Mbps (5.99Mbps) and if I watch the traffic in real time its 3.0Mbps up an down at the same time - so the configurator adds the 2 together but if I just do an FTP acr
Well we had another occurrence to AP "IP lockup", wireless link test good, rebooted the CPE, it sees the MAC address in the bridge table, but not under the IP ARP and there are bytes in/out on the wi
the firmware downgrade Unfortunately, Agere's if it is the short OEM card you can't downgrade the firm was it's a different chipset ( I think ) -- [This E-mail scanned for viruses by Declude Virus]
Whats the difference between the two? [mailto:karlnet-bounces@WISPNotes.com] II List" stop <karlnet@wispnotes.com> been about as modules don't field, set IP based a KN- with specific present in none
I just purchased 3 of these new kn50's..... I hope they work [mailto:karlnet-bounces@WISPNotes.com] <karlnet@wispnotes.com> load. with However loss 13 CPE devices points it. Hermes/Hermes no that uni
Did you test on the bench? Is it possible that there is a noise issue on ch#1? [mailto:karlnet-bounces@WISPNotes.com] wondering I'll customer CH1 it CH11! I packet support The the the similar to Lite
This works on remote cpes for SNR, it is a percentage though, if you can get into dbm's I'd like to see it - MaxBytes[t1cpe--]: 100 Target[t1cpe--nbgd]:.1.3.6.1.4.1.762.2.5.2.1.7.1&.1.3.6.1.4.1.762.2
I Have an ap1000 w/ 20 remote cpe's (rg1000's and kn50's) and I have noticed that the overall throughput seems to have dropped compared to when we had 10 or less cpe's... Is it possible the processor
Yes, I'm not seeing over 1.8mbps when testing from the LAN side of the AP Yes, it does have the faster processor, I have a kn205 I may test in its place _____________________________________________
Jayson -- You used a 24VDC POE? How long of an ethernet cable? Dan Metcalf Wireless Broadband Systems http://www.wbsysnet.com/ 781-577-2780 dan.metcalf@wbsysnet.com We cooked one of the KN-105's at 1
I Have a similar issue on an ap-1000, can you do a wireless link test to your clients? -- [This E-mail scanned for viruses by Declude Virus] _______________________________________________ Karlnet ma
You can do the link test while its locked up? But what do you mean by it won't register? You don't see it in the turbocell list or you can't PING IT? -- [This E-mail scanned for viruses by Declude Vi
I have the SAME EXACT issue, except I'm using an AP-1000 And I have hawking kn50's and some karlnet kn50's! Are your kn50's the hawking or the karlnet version? How many clients? I have almost 20 clie
Yes - I have those same units they are the hawking boards, I have 3 dead boards/radio's sitting here - they worked once and never worked again and only 2 in use, I wonder if it is those hawking board