Karlnet
[Top] [All Lists]

RE: [Karlnet] KN-50 Problem

To: "'Karlnet Mailing List'" <karlnet@WISPNotes.com>
Subject: RE: [Karlnet] KN-50 Problem
From: "Dan Metcalf" <dan.metcalf@wbsysnet.com>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Fri, 23 Jan 2004 10:45:52 -0500
List-post: <mailto:karlnet@WISPNotes.com>
Karlnet Support

Can you give us a time frame for the website update of license-it.com
for the kn50's?

Thanks

Dan


> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of KarlNet Support
> Sent: Friday, January 23, 2004 10:45 AM
> To: Karlnet Mailing List
> Subject: RE: [Karlnet] KN-50 Problem
> 
> Peter,
> 
> The firmware versions loaded over time have been 6.08, 7.52, 8.10 and
> currently 8.74. The radio card itself could have any of the versions
in
> between 6.08 and 8.75 and one of the versions mentioned above will be
> used.
> This also depends on the version of the software loaded to the KarlNet
> device.
> 
> KarlNet Technical Support
> http://www.karlnet.com/Support/Supportmain.htm
> 614-822-5275 x 128
> mailto://support@karlnet.com
> 
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com [mailto:karlnet-
> bounces@WISPNotes.com]On
> Behalf Of Peter Dordik
> Sent: Friday, January 23, 2004 6:03 AM
> To: Karlnet Mailing List
> Subject: RE: [Karlnet] KN-50 Problem
> 
> 
> Hallo,
> 
> > Neither the FlashROM nor the KN-xxx overwrite the firmware of the
card
> but
> > they do tell the radio to use a version of the firmware other than
what
> is
> > currently on the card
> 
> Of course, proper firmware is not overwrited (flashed), but loaded to
RAM
> of
> Orinoco (Hermes I) card.
> 
> > I believe there is an exception when it comes to
> > Intersil based radios. As you mention below the KN-50 does not do
this.
> 
> Yes, loading of firmware to RAM is reason, why we need care on
firmware of
> PRISM cards, while it is not important with Hermes cards. But Ubicom
HW is
> exception, because there is so small RAM and so small Flash, that was
> impossible for developers to make NAT or bridge filtering. So i think,
> there
> will be hard for developers to do autoloading of card firmware for
KN50.
> May
> be
> not.
> 
> 
> I know only 3 firmware for TURBOCELL, that are available:
> 
> 6.08 - WEP weak key problem
> 7.28 - too
> 8.10 - last?
> 
> Regards
>        Peter Dordik
> 
> >
> > We definitely appreciate the efforts of everyone on the list in
> attempting
> > to constructively resolve this and other issues and we will continue
to
> > follow through until it is resolved.
> >
> > As always questions and information pertinent to this and other
issues
> can
> > be sent to mailto://support@karlnet.com
> >
> >
> > KarlNet Technical Support
> > http://www.karlnet.com/Support/Supportmain.htm
> > 614-822-5275 x 128
> 
> 
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> 
> ---
> Incoming mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.563 / Virus Database: 355 - Release Date: 1/17/2004
> 
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.563 / Virus Database: 355 - Release Date: 1/17/2004
> 
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> --
> [This E-mail scanned for viruses by Declude Virus]


-- 
[This E-mail scanned for viruses by Declude Virus]

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

<Prev in Thread] Current Thread [Next in Thread>