Has anyone used KN bridge's (RG's in point-point mode) in an STP scenario? (triangle loop to be precise) We need to use STP enabled switches rather than the KN onboard STP feature. KN's STP works fin
Setup|Bridge Setup|Advanced Features|Enable Learned Table Lockdown? Then reboot, and it should remain pretty stupid, shouldn't it? At 09:36 PM 6/3/03 +1200, you wrote: Has anyone used KN bridge's (RG
http://www.hyperlinktech.com/web/pdf/sr2400_manual.pdf page 6 I'm not sure that the "learned table lockdown" will accomplish what you need. I'm not even close to a knowledgeable source on STP but fro
Sam, I have set up STP on Karlnet point to point RG-1000s. I was using cisco 2950 switches. They work great if you have STP turned on on the RGs. You will also want to tune the STP so that it primari
Thankyou for clarifying that John, I was originally *presuming* that by using switches in the triangle that did STP would take care of it - even if the actual links between had STP turned off and/or