Thanks ... I knew it had to be that easy! I probably should have gotten another night of sleep before trying to tackle the FD logs ... 14 hours last night just didn't seem like enough! 73, Ron
Ron is correct. 10.59 adds the "F" category, and was released a couple of weeks before Field Day. Unfortunately, our web site has been experiencing problems. The best way to describe it, is that ther
I am changing ISPs. Please not the new address. The old one will be ok for a short while. Thanks, Tom "E" Sorter for the ARRL W5 QSL Bureau Williamstown, WV
I am changing ISPs. Please not the new address. The old one will be ok for a short while. Thanks, Tom OOPS!!! THE NEW ADDRESS IS k5iid@earthlink.net "E" Sorter for the ARRL W5 QSL Bureau Williamstown
OK, what am I missing? I have the proper cable. Have tried known working com ports. Changed every setting I can think of. Yes, and I read the manual. I have now pulled out a bit more of my hair (what
Bob, You must not be going to Dayton - that's the only way you could be asking this question now. As for me, I leave for Dayton tomorrow morning - here's some quick ideas, but I won't be back on e-ma
Did you save the changes to the config files when you closed it? My 990 at 4800 baud works fine - nothing major had to be done - it was harder to get it going with CT - I just did same stuff as you n
I too have had no difficulty with the 990 at 4800B with NA. With CT I have to use the FT1000 setting to get the VFOs to work right. The way I check the 990-to-PC interface is to run an independent 99
Hi Jim, Oh yes, I saved everything. I bought the cable/level control adapter from a source that says the cable has been tested. I doubt it is the cable but then again you never know. As far as the CA
Here's another thought. I built my own interface using a MAX-232 chip and a couple of buffers. The cable did not work at first because the TTL levels coming out of or going into (I don't remember whi
== Dan Zeitlin Annapolis, Maryland http://members.tripod.com/~danzee/index.htm __________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com
It always helps to select RADIO1 in the pop-up window after starting NA. This was the ONLY reason my 990 rig control would not work (except for trying to run it from COM3 which you will read about be
This is most likely an IRQ problem. NA cannot share IRQs between COM ports. Windows let you do it, but that is irrelevent. Each COM port has to have its own IRQ. Also, is the COM3 port address correc
When you say "...after multiple attempts of changing irq's..." what does this mean? Are you changing the card, bios, NA config, other? The first question that needs to be answered is when you run con
It's probably a cockpit problem... I loaded V 10.85 onto two computers...one I'm using for WPX-CW, one I'm not. The one I want to use will not run NA in DOS. It will run fine in a DOS window, but not
Don't like to bother you with what is probably a 'cockpit problem'. I tried to post a message to the NA-user reflector, but was intercepted by the 'administrator' as I was not a member of that reflec
My apologies for not replying. I have been quite busy over the past 10 days. Today, I finally had some time to get out into the shack and work on this issue. Actually, in the shack is where I preferr