OK, what am I missing?
I have the proper cable. Have tried known working com ports. Changed every
setting I can think of.
Yes, and I read the manual. I have now pulled out a bit more of my hair (what
has not fallen out naturally).
Radio is a 990 which runs at 4800 baud. XCVR1 selected and set at 4800 baud.
Using 10.58. As far as I know I have the settings right.
Perhaps I am missing something simple and it would not surprise me if that were
the case. I have been on the "go" so much for the past 2 months and I am
tired. Not thinking clearly is pretty certain.
All I am trying to do at this point is connect 1 radio.
So do any of you NA guys have any input on this one?
Thanks!
Bob NX5M
|