Mail Archive Search: <+from:N4NT@chartertn.net>

Results:

References: [ +from:N4NT@chartertn.net: 194 ]

Total 194 documents matching your query.

141. [TenTec] Reciever comparisons (score: 1): Author: N4NT@chartertn.net (Mike Hyder -N4NT-); Date: Wed, 3 Jan 2001 17:37:16 -0500; Get three then agree to reduce inventory. Best Regards, Mike Hyder N4NT@chartertn.net Johnson City, TN -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions: tentec@contesting.com Administr; /archives//html/TenTec/2001-01/msg00065.html (8,077 bytes)
142. [TenTec] Jupiter- How easy to operate? (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Thu, 7 Dec 2000 09:20:20 -0500; ** Reply interlaced. . . for me to learn by study of a book. Do you use Windows 98? it. I use radio for relaxation and fun, not as an intellectual challenge. because it is seldom if ever needed. Ther; /archives//html/TenTec/2000-12/msg00068.html (12,167 bytes)
143. [TenTec] CW Note on Jupiter (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Thu, 7 Dec 2000 22:19:35 -0500; A nifty way to bring out any impurities in a carrier is to null it with your notch filter. The carrier is nulled but the modulation is not. Regards, Mike N4NT@chartertn.net obvious Perhaps something; /archives//html/TenTec/2000-12/msg00099.html (8,375 bytes)
144. [TenTec] TT Scout on batteries? (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Sat, 9 Dec 2000 07:31:36 -0500; You can probably get a Ten-Tec Argosy for about the same as the Scout. It will do fine at 12 VDC. Regards, Mike N4NT@chartertn.net solar on voltage would this -- FAQ on WWW: http://www.contesting.com; /archives//html/TenTec/2000-12/msg00126.html (10,195 bytes)
145. [TenTec] Easy to operate? (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Sat, 9 Dec 2000 08:12:02 -0500; Aw, shucks. This is easy. I fingered 'em all out. Regards, Mike N4NT@chartertn.net looking transceivers anything controls like, I them -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions:; /archives//html/TenTec/2000-12/msg00128.html (9,075 bytes)
146. [TenTec] TT Scout on batteries? (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Sat, 9 Dec 2000 17:25:04 -0500; Hi Tracy-- The manual specifies power requirements for the Argosy II (model 525D) as 12-14 Vdc regulated to 5% or better, 500 mA receive, 9A maximum transmit. I have used one down to 11.5 Vdc but hav; /archives//html/TenTec/2000-12/msg00139.html (13,372 bytes)
147. [TenTec] TT Scout on batteries? (score: 1): Author: N4NT@chartertn.net (Mike Hyder); Date: Sat, 9 Dec 2000 19:21:18 -0500; Is there a disadvantage to the Argosy compared with the Scout? Regards, Mike Hyder N4NT@chartertn.net Johnson City, TN 37601 It Scout at Scout This that -- FAQ on WWW: http://www.contesting.com/FAQ/t; /archives//html/TenTec/2000-12/msg00143.html (11,756 bytes)
148. [TenTec] weird noise on 10 meters (score: 1): Author: N4NT@chartertn.net (Mike Hyder); Date: Sun, 10 Dec 2000 09:27:28 -0500; I had noise very similar to what you describe except mine was on 15 meters. Its origin was a neighbor's "touch lamp." Good luck from Mike N4NT@chartertn.net -- FAQ on WWW: http://www.contesting.com/F; /archives//html/TenTec/2000-12/msg00148.html (8,383 bytes)
149. [TenTec] WTB: Ten-Tec Argosy II (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Sun, 10 Dec 2000 21:01:48 -0500; There is no point in having, and no provision for installing, a crystal calibrator in a 525D. The calibrator is only used and useful in the 525 analog Argosy. Regards, Mike N4NT@chartertn.net -- FAQ; /archives//html/TenTec/2000-12/msg00165.html (7,599 bytes)
150. [TenTec] Tritons Poppouri-II;540;544+PTO-WTD/FS-etc. (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Tue, 12 Dec 2000 16:35:50 -0500; I've rebuilt PTO's in an Argosy II, three Triton IV's, an Omni-C and a Corsair II. I've never yet seen any "smashed" wedge washers in them. Regards, Mike N4NT@chartertn.net -- FAQ on WWW: http://www.; /archives//html/TenTec/2000-12/msg00183.html (10,103 bytes)
151. [TenTec] SB-221 and Omni 6+ question (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Fri, 15 Dec 2000 08:47:26 -0500; Hi, Phil and everybody else-- 1. You can print out the schematic in two parts for the SB-220, if you point to ftp://bama.sbc.edu/downloads/heath/sb220/ 2. From Rich Measures website http://www.vcnet.; /archives//html/TenTec/2000-12/msg00216.html (10,254 bytes)
152. [TenTec] Omni C (score: 1): Author: N4NT@chartertn.net (Mike Hyder); Date: Sat, 11 Nov 2000 09:19:48 -0500; You said that the 17 and 12 meter bands on your Omni-C were "operational." You might check to see that the low pass filters are installed at the output. I believe those filters may not have been fact; /archives//html/TenTec/2000-11/msg00123.html (8,257 bytes)
153. [TenTec] Need power connector, Airpax 1140 breaker for TT 544. (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Mon, 13 Nov 2000 13:29:16 -0500; I've run a linear with a 544 for a long time with no trouble. Regards, Mike N4NT@chartertn.net -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions: tentec@contesting.com Administrative re; /archives//html/TenTec/2000-11/msg00140.html (7,705 bytes)
154. [TenTec] Triton IV Power Connector (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Thu, 12 Oct 2000 06:09:18 -0400; Earlier Triton IV's used a six-pin plug with a configuration like this: __ __ __ __ __ __ I want to say they were Amphenol connectors, but really don't remember. IV? seem -- FAQ on WWW: http://www.co; /archives//html/TenTec/2000-10/msg00152.html (8,059 bytes)
155. [TenTec] Triton IV Power Connector (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Thu, 12 Oct 2000 07:03:18 -0400; Yeah, I think that's it! Cinch-Jones sounds right. It's been some time since I thought about it and I've slept since then. Years ago I had a Heath mobile setup of the Cheyenne and Comanche which used; /archives//html/TenTec/2000-10/msg00155.html (9,837 bytes)
156. [TenTec] Corsair 2 (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Sat, 14 Oct 2000 23:30:36 -0400; If some signals do not warble and then when you change frequency a bit, some do warble, then it sounds like a PTO problem to me. That is the way they behave when the grease dries out. Perhaps there i; /archives//html/TenTec/2000-10/msg00171.html (8,386 bytes)
157. [TenTec] electron flow vs. current flow (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Wed, 18 Oct 2000 23:34:03 -0400; You guys need to go back to chemistry 101. Regards, Mike N4NT@chartertn.net -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions: tentec@contesting.com Administrative requests: tentec-REQU; /archives//html/TenTec/2000-10/msg00264.html (9,607 bytes)
158. [TenTec] electron flow vs. current flow (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Wed, 18 Oct 2000 23:38:06 -0400; The holes are where an electron isn't. If electrons flow clockwise in a circuit then the holes flow counterclockwise. Regards, Mike N4NT@chartertn.net the it was in states electrons -- FAQ on WWW: ht; /archives//html/TenTec/2000-10/msg00266.html (10,647 bytes)
159. [TenTec] F/S MODEL 705 DESK MIC (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Sat, 28 Oct 2000 23:21:51 -0400; One mouth, ten fingers. . . Regards, Mike N4NT@chartertn.net -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions: tentec@contesting.com Administrative requests: tentec-REQUEST@contesting.; /archives//html/TenTec/2000-10/msg00391.html (7,605 bytes)
160. [TenTec] Fence Charger Pulses (score: 1): Author: N4NT@chartertn.net (Michael O. Hyder); Date: Mon, 30 Oct 2000 22:13:55 -0500; I've only run into one problem with an electric fence. Was on a neighbor's land. Problem was the weeds had grown up into the fence in a few places. When the charger sensed that, it went into a "weed; /archives//html/TenTec/2000-10/msg00404.html (9,424 bytes)

Current List: 141 - 160
Page: [1] [2] [3] [4] [5] [6] [7] [8] [9] [10]