In addition to my faithful Argo 515 and Omni-V, I recently located an unbuilt T-Kit 1315 QRP xcvr for the 15 meter band. However, I have no assembly manual for the kit. Might someone have a manual fo
By way of comparison, my initial bench fee is $75 for inspection/analysis. Anything beyond that is time plus parts. The $75 is non-returnable. Vy 73, AI2Q, Alex Alectronix http://ai2q.org/Alectronix/
My new rig here includes six meters, so I've decided to sell my T-T 1208 6M transverter, with manual. I have been using it for the past three years with my Argonaut 515, and it works great. It is a Q
Doc, first check the seating of the small 2-pin connector on the audio board at the top of the chassis. In your troubleshooting, always work back from the speaker towards the audio amplifier, then th
Now that my shack includes a new rig that covers 6 meters I no longer need my trusty Ten-Tec Model 1208 trans-verter. The nifty little T-T 1208 accepts a watt or two at 14 MHz RF and generates about
Now that my shack includes a new rig that covers 6 meters I no longer need my trusty Ten-Tec Model 12Ø8 trans-verter. The nifty little T-T 12Ø8 accepts a watt or two at 14 MHz RF and generates about
Dale, you can make one using an optical encoder. Mine is mounted in a small box that sits on the operating table. It communicates with my Omni-V via a cable and the RS-232 connector on the back of th
It's been years since I looked at it, Dale. I'll try and find my notes. Vy 73, AI2Q, Alex On 8/26/2019 9:47 AM, dale via TenTec wrote: Alex thanks for the info. are there any special specs on the enc
It is normal, Gary. I actually find that to be useful. Vy 73, AI2Q, Alex Alectronix, http://ai2q.org The RIT (Offset Tuning in Ten Tec-speak) works as it should when on. However, when switched off, t
Sometimes a short delay has to be added between the time your rig is keyed and the amp is keyed. To be clearer, the amplifier must be keyed first, to ensure its T/R relay is connected to your antenna
Hi DJ, I suggest you use your ohmmeter (preferably a COM) to check the junctions of the bipolar transistors in the regulator circuit. Check devices from base to collector and base to emitter. Your r
Make that a VOM, not a COM. Sorry for the typo. == Vy 73, /AI2Q/, Alex I suggest you use your ohmmeter (preferably a COM) to check the junctions of the bipolar transistors in the regulator circuit.
John, check your balanced modulator circuitry. Vy 73, AI2Q, Alex My Omni 6+ has developed a problem. Here's the scenario All bands LSB only Any power level setting Keying the rig (pushing PTT) in LS