The Elecraft K3 comes to mind. And the just announced KX2. 73 K5AQ Y'all, I've taken on the job of talking to the Albuquerque Hamfest this coming August about significant advances in amateur radio
Bob, Thanks for saying what a lot of us have been thinking. After 66 years as a ham(62 as an Extra), First phone, Registered Professional Engineer, BS, MS and PhD course work in EE, I tire of instant
Cecil, I second Larry's recommendation. Glenn is a real professional. Ten Tec technician gave me nothing but a short cryptic answer alluding to lightning which had never happened. Glenn did an excell
Rick, Even dating myself more, I worked at Bell Telephone Laboratories in 1953 to 1956(with a time-out for the Signal Corps). Had the fun of designing a circuit using a point-contact transistor then
Good luck James. I have many of the same inclinations on researching things and also impulse buying. I also have a daughter who is an attorney! 73 Don K5AQ
Phil, Could you pass along the contact info for the pinball repairer who might have the DSP chip for the Omni VI. Mine is about to travel to Sevierville for service and the trouble is in the logic bo
Rip, Over the nearly ten years I haved owned my Omni VI opt 3, a reset has seemed to solved almost all the problems. Check the archives for a third reset not mentioned in the manual. Also, on rare oc
I use WinLog32 for similar activities and have been pleased with it. Several more capabilities are available than I use so you can expand if you want. No conncetion, just a satisfied user. 73 Don K5A
Jack, Check the TenTec Reflector archives. This problem has been extensively discussed in the past and many suggestions made. As I recall, all I had to do to cure mine was slightly detune the 20mHz o
Steve, The Auto is not useful for CW. As you found, it notches out the tone. On manual, you can notch nearby tones to improve copiability of the desired one. The Auto is a winner on SSB for eliminati