Based on the Argo 515 manual...........in the SSB normal (N) position, one should experience USB on 20,15, and 10..........and LSB on 80 and 40. I suspect the SSB generator area may need some checkin
Hi folks........ I'll check with TT to see if they have these readily available. But, if anyone has two of these, please email me off-line. I prefer black, but will accept two of any color as long as
Well Rick, how often do you use the SPLIT function without equalizing the two VFOs? And, that DOES require going into the secondary Function mode (and then exit it to use it for other functions). Any
Hello Eagle users..... I am interested in the Eagle and would appreciate input from CW ops. Specifically, I am interested in your experience with QSK and SPLIT, since these are important to me. I und
Carl.... Very sorry to hear about the hit. I have taken several of those and wonder if you would share whether or not you had your ground rod tied to your mains ground, i.e. making a single point gro
I "believe" my friend Barry meant the backlight control? I've had two O II's and didn't experience that problem. I have heard of folks having that problem with the Orion....and think maybe it was rel
It appears that the TX bandwidth is fixed at 2.4 KHz? So, there is no capability to control TX low and high end cuts? IE, you cannot set the TX bandwidth for 200-3000 Hz, etc? Thanks and 73 John W4II
It took a lightning hit, but many parts are fine. If you need a part, email me off-list. Case and front panel are near mint. Variables are fine. Band switch and rear PCB are toast. Cheap......not loo
John....the inductor tuning wheel has an arc mark on it from where it was touching the roller inductor at the time of the hit. John -- Original Message -- From: "JOHN" <ku3g@yahoo.com> To: "Discussio
Hi Jack....I'm sure you're right. I have not really looked closely at it. I have a buyer for 50 bucks, plus shipping....as is. 73 John -- Original Message -- From: "K2RS" <K2RSonline@comcast.net> To:
You are correct Carl..... John W4II -- Original Message -- From: "N4PY2" <n4py2@earthlink.net> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Saturday, October 23, 2010 12:19 PM
I have the following.....all MINT, as new; non-smoker. Model 310 fan Model 712 USB cable Custom Cover (embroidered) Orion II TT gray polo shirt 2X, never used. 85 bucks shipped. 73 John W4II fraz1 at
Francisco.... I have had the bracket for both Main and Sub VFO encoders loosen. I removed the front panel, and tightened the screws holding the bracket in place. All of the "play" disappeared. You ma