Hello Michel, I'm not going to go into a lot of technical numbers, someone else has sent you a good comparison of the Delta II, OMNI VI, and ICOM IC-765. I will, instead, give you my opinion of the D
Hi Larry, I think we all have "Been there and done that!" Now if Ten-Tec would give us a T-Shirt we could finish that statement with "and have the T-Shirt!" Oh, you don't have T-shirts......okay then
Hi John, What a great story! Glad your dream finally came true. I did get my license at age 13 thanks to a local "Elmer" and have enjoyed the hobby for the last fifty years! I have been trying to res
I can tell that the engineering staff is hard at work designing SDTA.......that's Software Defined Towers and Antennas! Looks like you need to tell Jack Burchfield what you want for Christmas! Sorry
Stan, I'll take one of the 961 P/S if still available. Let me know and I'll give you a call on Friday. M.P. "Pat" Haynes 241 Hunter's Ridge Jasper, GA 30143-3270 (706) 692-0279 ______________________
Hello Peter, I have a Paragon that I bought used in 1992 and it has served me extremely well since. I had problems with one of the phase lock loop boards but resoldering it fixed the problem permanen
Nick, I'm sorry to say that I don't know for sure if it can or not, but I believe there is one wire you can cut that will enable transmission on any frequency. Maybe someone else can answer for sure.
Please, this is a family reflector, Don! Danke schoen, Pat - K4BEH ________________________________________________________________ The best thing to hit the Internet in years - Juno SpeedBand! Surf
Hi Bob, I agree with you on the hand pump but must admit that I use ASCII mode with my keyer, especially handling traffic or working Field Day! Then again I have heard some absolutely awful CW sent w
Hi Guys and Gals, My thoughts on this phenomena is that it is due to the skirts of the filters not passing the received audio below a nominal frequency of probably 300 hZ or so. This would be a norma
Hi Bob, The best way I have found to accurately determine my receiver frequency is to simply tune in WWV and listen to the modulated AM DSB tones. As you listen with your rcvr in SSB mode simply swit
Hi Bob, That sounds like the 5kw I.T.A. (I believe that was the company) that we had at WSEV in Sevierville in 1960 and 61. It was terrible, lots of parasitics that would take out the screen bypass c
Hi Duane, I had a similar symptom when I first bought a used Paragon and tried to operate it off a battery. It does strange things on less than 13 volts VCC. Pat-K4BEH _______________________________
Hi John, I would first look at the Low Pass Filter board. It sounds like one of the relays (input or output) is not making good contact. Also check to see that the voltage that pulls the relays in is
CHILDREN, CHILDREN! DON'T MAKE ME STOP THIS CAR! SETTLE DOWN BACK THERE! ________________________________________________________________ The best thing to hit the Internet in years - Juno SpeedBand!
Hi Jamie, I never owned the original Delta 580 but do own the Delta II. The Delta 580 had a permeability tuned oscillator much like the older OMNI's, Tritons Corsairs, etc. They were noted for their
I guess that makes a filter in the audio out circuit a basement filter! Pat- K4BEH On Fri, 6 Aug 2004 21:54:23 +0200 "Marijan Miletic, S56A" <s56a@bit.si> writes: ____________________________________
Bill, Yes, the 961 supported the OMNI V and the Paragon. The only difference in the two is that one does the regulating on the plus side of the diode bridge and the other on the minus side. I believe
Hi Steve, I ran the Delta II mobile for about five years in the early 90's in a variety of Fords, 2 Taurus's and an Aerostar van. It is an outstanding performer mobile. The only shortcomings are 1, i
Hi Folks, Interesting thread here. Isn't there a power limitation of 50 watts on the sixty meter channels? If so, why worry about interfacing a Herc for that band? You wouldn't be planning anything i