I just can't see any viable reason to not try/own an Orion. Especially any technical reasons. I don't have one as yet and have little actual time using one. But I do think about it. Unfortunately it
Does anyone know if there is a manual (or even just a schematic) of the TenTec 1202 wattmeter available on line any place? Ten-Tec sells copies of ALL their manuals for everything they have sold. Ch
To slighltly paraphrase an old cliche, do you want it done right, or do you want it done Tuesday? 73 I am fortunate in that having Ten-Tec gear allows me the freedom to perform my own repairs (when
For these reasons I'm holding off my Orion purchase until v2 of the firmware comes out and the Orion owners/users/abusers have their say. I don't demand a *perfect* radio. Just one that doesn't hang
Setting up a Retro Century 21 station here. I used one of these 25 years ago. My rebuilt Century 21 is going strong. Now I would like to complete the station: 1) I am looking for the Calibrator optio
Can a D-104 microphone be used, with good results, on a Paragon ? _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listin
The stock D-104 requires a very, very high impedance for it to operate with its designed frequency response curve. Depending on the vintage of the crystal element it works best from somewhere between
Sir Do you have a manual fo the Century 21D. With regard Iet Tresoor Netherlands _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com
Yes, a few months back I agreed to trade my Omni-C station (power supply, remote vfo, speech processor, mic, and all filters) for a non Ten-Tec rig. Now I had owned that Omni-C for 24 years but I als
Well a single Orion is way outside the budget of most amateurs (well at least me). Two Orions is well another matter altogether. You can buy a nice Omni-C station for probably under $600. We are talk
I just did a PTO rebuild on a Century 21 that I got off eBay. Yes, I knew up front that the PTO had problems before I bid on it. Got the rebuild kit from Ten-Tec which basically replaces every small
Lesson is: You canīt be to careful shopping at the net. And stick to this site, after all we are all amateurs and gentlemen... I wish that were true. Fact is my two worst trades, as far as equipment
For Sale: Mint Ten-Tec RX-350, mint matching external speaker, mint matching remote encoder, perfect original manual (I am the original owner of these). Everything works perfectly. Sold together only
I just purchased a Corsair II and remote VFO for my station Malcolm and I expect that I will be doing PTO rebuilds as well just as a matter of course. I just competed a PTO rebuild on a Century 21 us
Well I finally found what I hope to be a very nice Corsair II station complete with all filters, 960 PS and remote VFO. It should be delivered in about a week. It won't be the same as my venerable Om
For Sale: Ten-Tec RX-350 DSP communications receiver (Matches Jupiter) Also including Model 307 external speaker, Model 302 remote encoder/keypad, and original manual. All fully functional and in 'mi
For Sale: Ten-Tec RX-350 DSP communications receiver (Matches Jupiter) Also including Model 307 external speaker, Model 302 remote encoder/keypad, and original manual. All fully functional and in 'mi
For Sale: Ten-Tec RX-350 DSP communications receiver (Matches Jupiter) Also including Model 307 external speaker, Model 302 remote encoder/keypad, and original manual. All fully functional and in 'mi
For Sale: Ten-Tec RX-350 DSP communications receiver (Matches Jupiter) Also including Model 307 external speaker, Model 302 remote encoder/keypad, and original manual. All fully functional and in 'mi
For Sale: Ten-Tec RX-350 DSP communications receiver (Matches Jupiter) Also including Model 307 external speaker, Model 302 remote encoder/keypad, and original manual. All fully functional and in 'mi