I believe you could consider the Delta 580 as TenTec's first Dual Conversion receiver. The first IF was at 11mhz and the second was at 6.3mhz. The 11mhz IF had a roofing filter with no optional filte
I've been looking at N3FJP's pgm but it only has settings for one radio and no cw keyboard pop-up. I'm using the Paragon II and Omni VI, neither which is on his rig list! I managed to get them runnin
The only difference I can find between the Paragon II and Omni VI's interface is the speed. The P2 is fixed at 1200 baud otherwise all is the same. Thanks for the tip though. I've been playing with L
So a rig with an A/D convertor for transmit and receive qualifies it as SDR. The first ham rig I can recall having those features would be the TS-870. Being upgradable and having encoders for control
I have stumbled upon perhaps the best Paragon II around and am offering it for sale due to a surplus of rigs around here. Paragon II General coverage receive AND Transmit. (60meters)! AM, FM, USB, LS
On the logic board is a white wire between two points labled "ham". Remove it. This opens the rig up for general coverage tx, a 2 minute mod! Steve N4LQ -- Original Message -- From: "designer" <desig
Repost with corrections: Filters are khz, not mhz. I still think they should be cycles. Steve N4LQ -- Original Message -- From: "n4lq" <n4lq@iglou.com> To: <tentec@contesting.com> Sent: Tuesday, Dece
Go here to view: http://www.webham.com/PARAGON%20II/index.html All filters. Low hours. Just back from TenTec for alignment. $1495.00 + Shipping Email n4lq@iglou.com Steve N4LQ
I tried putting a DSP filter inside the agc loop on a Triton and it made the pop problem a 100 times worse due to the log delay. Don't count on that working. Steve N4LQ -- Original Message -- From: <
you need to talk to tommy w4bqf about the amp loop problem Steve N4LQ -- Original Message -- From: "Gary Tuck" <gtuck@mac.com> To: "Ten Tec Mailing List" <tentec@contesting.com> Sent: Wednesday, Dece
I doubt if you even need the interface John. The Corsair's amp relay is big enough. Better check the PTO for smoothness. Other than that, have fun! Steve N4LQ -- Original Message -- From: <john.brewe
bottom right corner.....PWR Steve N4LQ -- Original Message -- From: "Vince Santis" <vsantis@earthlink.net> To: "Tentec" <tentec@contesting.com> Sent: Thursday, December 16, 2004 8:12 PM Subject: [Ten
I agree. The MFJ is hard to beat. I haven't tried that SCAF filter but since it's only a "low pass" filter you will still hear the thumps and rumble of the LF noise. Steve N4LQ -- Original Message --
sorry...sold and gone Steve N4LQ -- Original Message -- From: <CROCDONZ1@aol.com> To: <tentec@contesting.com> Sent: Friday, December 17, 2004 12:56 PM Subject: Re: [TenTec] FS: Paragon II Rare and Be
That among other bugaboos is why they came out with the Paragon II. There was a chip called the Giehl Chip which addressed this problem but probably no longer available. I would check the charging vo
The Corsair II would drive you nuts in that situation. It's audio derived AGC would pop your eardrums on the stong signals so you reduce the RF gain then you can't hear the weak one's while the Omni