gang. a little plug for me. I have a drop in replacement for that external amp keying module that fits inside the Ten Tec Argosy. I have plenty of pcbs, but im not sure if I have any preassembled. Mi
bob and the boys... the original ten tec amp accessory did provide a delay. There is (was) a small trimmer on the pcb to set the time. My replacement provides a way of adjusting the t/r delay time, t
I use the vox with my omni 7. no signal link. Only the acc plug that goes to the computers audio cord. works great! Mike, WB8VGE SunLight Energy Systems The Heathkit Shop http://www.theheathkitshop.c
gang, the SB-200s key line sits about MINUS 130 ish volts DC. Mike, WB8VGE SunLight Energy Systems The Heathkit Shop http://www.theheathkitshop.com/ J e e p o|||||||o A man with one clock knows what
The EEEEEE on the display indicate a fault in the counter. Most likely RF The display is nothing more than a frequent counter There is no out of band error in that radio Mike wb8vge Sent from my iPad
Heres one example where if it walks like a duck. Theres no question, and without having the radio in front of me, that RF is getting into the counter circuit. Id bet RF is also into the audio. Does h
Okay. first off is the audio filter working correctly? Do you have all three filter stages? if you do, then the IC LM3900 is working. There are four sections to that amp, three are used for the audio
gary, that supply is very simple. if you have 25 V AC from the secondary of the transformer yet no dc on the cap, check the bridge rectifier. They have been known to go bad in that radio. Most likely
tom. have you looked at the reed relay on the output board? I had an Omni C do exactly the same thing. No TX and the rec was way off. The reed relay had its contacts fail Mike, WB8VGE www.theheathkit
tom, I never could find a replacement. The factory doesnt have it anymore either. I took a SPDT reed switch, the glass switch, and extended its leads so I could make the necessary connections Slip th
gang. Im looking to sell one of two Ten Tec Omni Vs that I have here. They are both fully functional, and are in extremely nice shape. They dont come with filters, but some are available. I can send
bud, a simple test unplug the secondary of the transformer from the power supply filter caps replace fuses and try to power it up. if the fuses hold, the capacitors/diodes are at fault If fuses blow,
Jim, thats quite common. Someone at one time wired the power switch up to turn on/off the high current dc. Thats not how that switch operates. It controls the AC on the ten tec power supply. Id bet t
The 6333 is tripled to 19 mhz. You dont insert this freq I dont have the manual in front of me so I cant tell you where to look for the 19 mhz freq Mike, WB8VGE SunLight Energy Systems The Heathkit S
Gary. yes they did. I too had a scout on my bench and it had FET drivers. If I remember correctly, there were FETs in the PA as well. At the time, I called and talked to Gary at Ten Tec and he told m