Have a as new ten tec jupiter transceiver, last of the production run. The radio has the black case and blue screen. No operational issues of any kind, cosmetics are a 9.9/10. the radio has the match
radio has been sold 73 dale What is your off list email address? Fernando N2FQ/6 n2fq@sbcglobal.net _______________________________________________ TenTec mailing list TenTec@contesting.com http://li
About a1/2 hour ago. still looking for a 302 dale I take it you found rig ________________________________ From: TenTec <tentec-bounces@contesting.com> on behalf of dale via TenTec <tentec@contesting
Reading in the jupiter manual, it states the external speaker jack is not grounded and the output is floating. I have seen suggestions that a audio isolation transformer should be put on line between
I was planning to trade off some collins equipment and received a offer to trade the collins ,about 1100.00, for a Orion I. Is this a rig to stay away from? Has tuner, all filters, updated to blue sc
Arthur not a program and change out I would want to try, myself. Guess I will just keep my flex 5000a and maybe the collins kWh-2 also. thanks dale wt4t Asked Mike same question when stopped at the t
i have an omni VII with the 2 optional cw filters, cooling fan, internal tuner, manual and power cord. no mic. it will be back from ten tec next week. $1500 with some help on shipping. e mail me kart
I was working on my Omni VI and put it back in its position on the desk. Rehooked everything and turned it on. There was no receiver output, the radio was on and totally deft. Shut it down right away
Just bought a omni-V, It has a N4PY chip installed says version .9? the radio does not have any of the chips stickers left on the buttons. I beleive there may be a latter chip from N4py 9.2? and any
If your using a stock OMNI-V ,No N4PY chip, how do you calibrate the display, if not reading correctly? On 14.300 I read 14. 299.87. Read thru the manual but must have missed it . Would really apprec
I downloaded the instruction pages from carls website. went to the crystal calibration section. Here is what is going on. I made paper labels for all the buttons per the website. frequency I want is
Thanks to carl and others problem solved, I had labeled the bottom row on the keypad wrong, needed to label the row above. switched the labels ,all is good. calibration now dead on. thanks dale wt4t
Joe the labels are no big deal. unless you want the OMNI-V to look like it came from the factory. My V had the chip, but no labels. I down loaded the pdf from carls site about the chip. He has the la
Anyone have a 1.8 filter for the 6.3 IF, or a 1.8 for the 9.0 IF? Also would like to get the speech board and the FM board.ten tec or inrad filters are fine. 73 dale wt4t
Sent my OMNI_VI to ten tec two weeks ago. Just was not running up to snuff,like it used to. Heard from them today. the rig was way out of alignment and also the bandpass and bfo. They told me the no
When I wrote my original e mail about ten tec being unable to repair the noisy mixer board on my OMNI-VI, I think the point of the e mail was lost. I do not have the bench or the test gear any longer