Search String: Display: Description: Sort:

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TenTec\]\s+Johnson\s+PS\s+\?\?\s*$/: 6 ]

Total 6 documents matching your query.

1. [TenTec] Johnson PS ?? (score: 1)
Author: Gaardens@surferie.net (Rich Gaarden)
Date: Sun Feb 23 15:24:28 2003
Hi Folks, This is off topic I suppose but the PS will be used on Ten-Tec equipment! I acquired a very heavy 40# perhaps PS which is not properly regulated (16 V). I was told it was from a repeater an
/archives//html/TenTec/2003-02/msg00865.html (7,526 bytes)

2. [TenTec] Johnson PS ?? (score: 1)
Author: geraldj@isunet.net (Dr. Gerald N. Johnson, electrical engineer)
Date: Sun Feb 23 15:54:41 2003
It may take a minimum load to regulate. Try it with a 3 or 4 amp load. 73, Jerry, K0CQ -- Entire content copyright Dr. Gerald N. Johnson, electrical engineer. Reproduction by permission only.
/archives//html/TenTec/2003-02/msg00866.html (6,882 bytes)

3. [TenTec] Johnson PS ?? (score: 1)
Author: w5yr@att.net (George, W5YR)
Date: Sun Feb 23 17:52:24 2003
Sounds like a linear (non-switching) non-regulated power supply using LC filtering. By non-regulated, I mean that it sounds like it does not use electronic regulation to maintain the output voltage c
/archives//html/TenTec/2003-02/msg00867.html (8,395 bytes)

4. [TenTec] Johnson PS ?? (score: 1)
Author: Cellobrown@aol.com (Cellobrown@aol.com)
Date: Sun Feb 23 18:04:17 2003
Dear OM: This power supply sounds as though it is a full wave supply with choke and capacity filtering. If you want it regulated, you should add a regulating section to it, and you should have a winn
/archives//html/TenTec/2003-02/msg00868.html (6,838 bytes)

5. [TenTec] Johnson PS ?? (score: 1)
Author: kitdart@ntelos.net (The Indart)
Date: Sun Feb 23 22:08:36 2003
Hi, Assuming that the P.S. is operating normally; I would use a string of silicon power rectifiers in series to reduce the output. A silicon rectifier (any kind) will have a .7 volt drop across it. T
/archives//html/TenTec/2003-02/msg00873.html (9,292 bytes)

6. [TenTec] Johnson PS ?? (score: 1)
Author: feutz@wctc.net (Ron Feutz)
Date: Sun Feb 23 22:56:15 2003
Rich, I tried to reply off-reflector but your email address on QRZ bounces. I am an EFJ dealer and if you can send me a pic or model number I will try to ID the PS and will send you a copy of a manua
/archives//html/TenTec/2003-02/msg00875.html (10,620 bytes)


This search system is powered by Namazu