I need a replacement speaker for my TenTec Argonaut 509. TenTec no longer sells them. This one is a 2.5" diameter round 8 Ohm speaker. Has anyone found a source that I can get a replacement. Thanks a
Jack, Futurlec lists a medium speaker which is 66mm diameter (2.6 inches), 4 ohms, with a 1W power rating for $1.30. You can see the speaker at: <http://www.futurlec.com/Speakers.shtml> Jerry W5JH "b
I saw some on Parts Express that looked like a fit They are rugged, right size, extended response. Very enticing. Less than $10 Paul K0UYA _______________________________________________ TenTec maili
Jack, I have one in perfect condx, as the original Omni series speaker is exactly the same as the 509's speaker. I will contact you directly off-list. 73 Don W9CW On 1/1/2013 5:26 PM, Jack Van Demark
Thanks to all for the help 73 and Happy New Year. Jack WN5A I have one in perfect condx, as the original Omni series speaker is exactly the same as the 509's speaker. I will contact you directly off-
I bought a number of these speakers from Jameco several years ago and installed several in Ten-Tec rigs. They fit perfectly and are stouter speakers than the original. You can tell by the magnet stru
Sorry. After getting out my magnifier I see that the speaker number I used was the 99995 AND NOT THE 99996. I cannot vouch for the 99996. Sorry for the confusion. 73, Mike N4NT I bought a number of t
OK. Here's the skinny on the Jameco speakers, straight from a Jameco rep's mouth. The model 99995 which I purchased six of back in 2003 has been replaced by the Jameco model 99996. The only differenc
Mike, the Jameco speaker actually screws right in where the old Corsair II speaker was without modification/drilling/adapting? If so, that's amazing. Tnx/73, Barry N1EU ______________________________
I think I put one in the Corsair II but I've since lost it and cannot tell you. The new speaker with the other rigs I mentioned mounts inside the cabinet and the mounting holes mate up with the screw