I brought the rotator down and the only thing I could find that was a problem was dried up grease. So I lubed the whole affair up with white lithium grease on both bearing races and gears. Bench test
will will remain North above of tower to is to rather this We Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA. ________________________
I am sitting here looking at my new 800 Yaesu rotator and all 4 parts, 2 clamps for the upper and 2 clamps for the lower that I have all have the same appearance and even the same identical part numb
I was recently given for an early birthday present a SGC 239 auto tuner and a stainless whip. The whip I mounted in the corner of the bed of my truck with a very short hunk of coax coming in through
Anyone have a working link to this antenna? Nothing in previous posts works for me all dead links. _______________________________________________ See: http://www.mscomputer.com for "Self Supporting
Can anyone suggest some bullet proof antenna traps for a trapped inverted V for 40/80 and 160 I need a pair for 40 and a pair for 80 and will use stinger on end of antenna to resonate to 160. The una
I hate to say this but why are you so concerned about the jungle attenuation when there is nothing you can do short of slash and burn to eliminate it for miles around you. When I lived in the Philipp
Well I have to agree on applying a suitable rotator that is oversized so you do not have mess with it very often. I have turned an A3S for many years with an Alliance rotator, it finally bit the dust
I have the Challenger and let me tell you it is a good vertical on 40 and 30, 80 is ok. I have been told the Voyager is a good 80, 160 is ok antenna. Gene Bigham KB0GU _______________________________
Congratulations on a great showing Bob. Best Regards Gene KB0GU _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contes
I did not use nails, but large staples that are available from the Wal Mart and others, these are aluminum I think and about 6 to 8 inches long, they hold the wire down until the sod grows over in le
Do you have a single coax going into the tub or a bundle of coaxes and control cable for the rotator? Thanks, Gene _______________________________________________ ____________________________________
I have here for sale an Aluma tower T-150 which is the A and B section and extends to 50 foot. It is bracketed against the back of my house at the roof line about 20+ foot up. This tower, and the pre
I have here for sale an Aluma tower T-150 which is the A and B section and extends to 50 foot. It is bracketed against the back of my house at the roof line about 20+ foot up. This tower, and the pre
Ok, I am listing this again, I have an aluma tower 50 foot crankup in good condition, it cranks up and down nicely, it has the hinge base on it, but let me tell you that is pretty marginal. It has wo
I found this out trying to use a six foot stainless CB whip with auto tuner in bed of truck under it. No mount insulator on the market would withstand the voltage generated by a 100 watt output radio
Looking at Glenn Martin 26 foot tower, to mount on my deck about 8 foot below the eve and extended above the peak of the house with an Archer rotator, masting, and H frame 4 element 1296 MHz beam set
I would like to know too as I bought the Harbor Freight several years ago and have just never gotten around to installing it as high up on house and as close to the nested height (25 ft) of a 50 foot
Anyone with any experience with this small tower? I realize it is designed for roof top mounting, but I am going to bolt the base to my deck, using lumber under decking to strengthen mount, decking i