Mail Archive Search: <+from:jms

Results:

References: [ +from:jms_k1sd@verizon.net: 11 ]

Total 11 documents matching your query.

1. [TowerTalk] Coax Seal (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Sun, 19 May 2013 17:18:53 -0400; Coax Seal is easy to remove. Apply one layer of cheap electrical tape over the connectors and then cover that with coax seal. Easy to remove. 73 James K1SD ___________________________________________; /archives//html/Towertalk/2013-05/msg00251.html (6,672 bytes)
2. [TowerTalk] Vertical Radials (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Tue, 25 Jun 2013 09:24:47 -0400; I'm going to be phasing a pair of verticals (HF2V) on a small lot. Should each vertical's set of radials be isolated from each other or would it be OK to allow them to overlap. Or, would it even be m; /archives//html/Towertalk/2013-06/msg00379.html (7,202 bytes)
3. [TowerTalk] Cutting a dipole (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Wed, 04 Sep 2013 18:32:38 -0400; Greetings I should know this but I've not made too many dipoles. While it is hanging at 8 feet so I can get to it, I've cut a 40 m dipole to the frequency I want. When I raise the apex to 65 feet as; /archives//html/Towertalk/2013-09/msg00061.html (6,652 bytes)
4. Re: [TowerTalk] Cutting a dipole (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Fri, 06 Sep 2013 17:30:06 -0400; Thanks for all the replies (especially the beneficial ones). I got what I wanted. 73 James K1SD _______________________________________________ _______________________________________________ TowerTa; /archives//html/Towertalk/2013-09/msg00105.html (7,857 bytes)
5. [TowerTalk] HAM IV Height (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Thu, 19 Sep 2013 11:35:16 -0400; Greetings, I'm replacing a HAM IV with a Yaesu G-800GXA and concerned about the depth of the mast into the rotor housing. What is the dimension on the HAM IV from the mounting plate to the point that; /archives//html/Towertalk/2013-09/msg00251.html (6,575 bytes)
6. Re: [TowerTalk] HAM IV Height (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Fri, 20 Sep 2013 13:23:42 -0400; Gentlemen, Thanks for the replies. I just came down from the tower and the swap went off without a hitch. An easy remove/replace. 73 James K1SD From: James Setzler [mailto:jms_k1sd@verizon.net] Sent:; /archives//html/Towertalk/2013-09/msg00262.html (8,151 bytes)
7. Re: [TowerTalk] Raising 25G with a helicopter (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Thu, 24 Oct 2013 14:53:40 -0400; Candidates for a Darwin Award. 73 James K1SD -- Message: 6 Date: Thu, 24 Oct 2013 12:51:56 -0500 From: Nate Bargmann <n0nb@n0nb.us> To: towertalk@contesting.com Subject: [TowerTalk] Raising 25G with; /archives//html/Towertalk/2013-10/msg00337.html (8,200 bytes)
8. [TowerTalk] HF2V Elevated or On Ground (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Wed, 13 Nov 2013 15:48:40 -0500; Greetings, I've a Butternut HF2V that used to be elevated with the feedpoint at 10 ft. and 2 tuned radials each on 40m and 80m also at 10 ft. I was satisfied with it; it seemed to hear well enough an; /archives//html/Towertalk/2013-11/msg00250.html (7,192 bytes)
9. [TowerTalk] HF2V Elevated or On Ground - Redux (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Fri, 22 Nov 2013 13:31:28 -0500; Mike, Thanks to you and everyone who responded the my question about the Butternut HF2V. There is a wealth of information that was shared and I've been doing a lot of research in the last few days. T; /archives//html/Towertalk/2013-11/msg00402.html (7,305 bytes)
10. Re: [TowerTalk] Looking for M/F 8 pin connectors for rotor (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Mon, 20 Jan 2014 16:05:33 -0500; They're not easy to find, but trailer connectors work great. Rugged and water resistant. 73 James K1SD -- Message: 4 Date: Sat, 18 Jan 2014 14:28:35 -0500 (EST) From: r miles <greenacres113@charter.n; /archives//html/Towertalk/2014-01/msg00279.html (8,593 bytes)
11. [TowerTalk] FW: [Yaesu] Rotor connectors (score: 1): Author: "James Setzler" <jms_k1sd@verizon.net>; Date: Sun, 22 Feb 2015 15:01:31 -0500; Steve, I've never bought from Tom, but he probably has the part you're looking for. 73 James K1SD -- I have available replacement OEM cable connectors for Yaesu Antenna Rotors & Controllers. Yaesu mo; /archives//html/Towertalk/2015-02/msg00406.html (9,174 bytes)

Current List: 1 - 11
Page: [1]