I bought a crimping tool at Dayton with two dies, but the openings in the dies are identified only by dimensions, not by the connector they are to be used on. I've tried Googling without success, but
Hi Pete, Here is a size chart that might be of help. http://www.rfparts.com/picts/1505_chart.jpg Good luck! 73 Bert, VE3NR I bought a crimping tool at Dayton with two dies, but the openings in the di
Pete, Look at Standard Die Sets on this page: http://www.rfparts.com/coax_accessories.html Might help. 73, Les W2LK _______________________________________________ ___________________________________
Pete, Try this page too: http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40 <http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40> Go about 2/3 down th
I too would appreciate a copy, Thanks, Dick, W1KSZ _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http