Hi Pete,
Here is a size chart that might be of help.
http://www.rfparts.com/picts/1505_chart.jpg Good luck!
73 Bert, VE3NR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Pete Smith
Sent: Tuesday, June 07, 2011 7:45 AM
To: TowerTalk
Subject: [TowerTalk] Which crimper die for which connector
I bought a crimping tool at Dayton with two dies, but the openings in the
dies are identified only by dimensions, not by the connector they are to be
used on. I've tried Googling without success, but suspect there must be a
table somewhere that I can use for reference - any ideas?
--
73, Pete N4ZR
The World Contest Station Database, updated daily at www.conteststations.com
The Reverse Beacon Network at http://reversebeacon.net, blog at
reversebeacon.blogspot.com, spots at telnet.reversebeacon.net, port 7000
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
