Hi all, While the readouts run on DC, the CDE/HyGain Ham-X series MOTORS run on 24v. AC.. bill, k1DY _______________________________________________ VHFcontesting mailing list VHFcontesting@contestin
Kevin, Since the phasing lines in this situation are flat 50 ohms, they are not impedance transformers and so do not need to be multiples of any portion of a wavelength, they just need to be the SAME
Hi gang, Cleaning out the junk box.. actually this is not junk.. I have some low noise GaAs FETs that are excess to my needs. maybe just in time to repair that preamp before the contest? 6 MGF1302 @
Ooops, Guess I ought to say who i am.. bill, K1DY in Maine!! _______________________________________________ VHFcontesting mailing list VHFcontesting@contesting.com http://lists.contesting.com/mailma
Hi everyone, Still cleaning up here.. I still have a few MMIC's and GaAs FET's left. They are listed below: 5 MAR-6 @ $2 each 4 ERA-1 @ $2 each 4 ERA-2 @ $2 each 1 ERA-5 @ $5 2 MGA-86576 @ $5 each 6
IMFET's are sold.. bill _______________________________________________ VHFcontesting mailing list VHFcontesting@contesting.com http://lists.contesting.com/mailman/listinfo/vhfcontesting
chip caps are sold bill _______________________________________________ VHFcontesting mailing list VHFcontesting@contesting.com http://lists.contesting.com/mailman/listinfo/vhfcontesting
the used MGF1302's are sold bill _______________________________________________ VHFcontesting mailing list VHFcontesting@contesting.com http://lists.contesting.com/mailman/listinfo/vhfcontesting
Hi Joe, Bill Olson recommends Directive Systems Yagis for the lower 4 bands and also Directive Systems Loop yagis for 33cm on up.. yeah you might say I am biased, but I use both on my rover and have
Hi gang, If anyone needs some low loss jumpers for 5 or 10gHz dishes, I have brand new Andrew FSJ1-50A Superflex and brand new Andrew SMA male connectors to match. (also a few N-males). I can make up
Hi gang, If anyone needs some low loss jumpers for 5 or 10gHz dishes, I still have brand new Andrew FSJ1-50A 1/4" Superflex and brand new Andrew SMA male connectors to match. (also a few N-males). I
Hi gang, I was cleaning up and found another batch of "good used" MGF1302's. These have full length leads and were removed from preamps that I had build for a customer in the mid-east that needed mor
MGF1302's all gone (guess i wasn't asking enough!!) thanks guys.. bill Hi gang, I was cleaning up and found another batch of "good used" MGF1302's. These have full length leads and were removed from
Still cleaning up here. I have: 4 brand new Avantek ATF13135's these have long leads and were used in the original Al Ward WB5LUA 10gHz preamps. $5 each 5 brand new Avantek AT8140. This is a 1 watt 6
Hi gang, If anyone needs some low loss jumpers for 5 or 10gHz dishes, I still have brand new Andrew FSJ1-50A 1/4" Superflex and brand new Andrew SMA male connectors to match. I can make up cables any
oops.. There really WERE words there!! don't know where all that disappeared to!!.. hang on bill K1DY.. -- _______________________________________________ VHFcontesting mailing list VHFcontesting@con