great keep us all posted - hopefully there is a reader who perhaps is a technician who can put together kits for us QCAO types to create outboard RIT (ooops Clarifier) knobs... that sure would be gre
G'day, I experience problems setting the clarifier using the CAT interface. The following commands are function ok as expected: opcode | data1 | data2 | data3 | data4 | description -- 0x09 | 0x00 | 0
Something I would like to have is a remote knob for the FT1000 - a knob which would adjust either (or both) the VFO and the RIT/Clarifier that I could place along side the keyboard so I didn't have t
Jim - If there is a separate knob, you're STILL gonna have to take a hand off the keyboard arent't you ? Or did I miss something ? Now a foot operated slider..... 73, Mike NF4L -- Original Message --
I used the Omni VI before the Yaesu...the remote vfo knob for that sat alongside the keyboard - much easier than moving arm to adjust frqequency - it was basically a left right predominantly wrist th
Author: Bill Coleman" <n2bc@stny.rr.com (Bill Coleman)
Date: Fri, 29 Nov 2002 11:26:51 -0500
You might try the N1MM LOGGER software here: http://pages.cthome.net/n1mm/ It will go up/down with the up/down arrow keys (100hz in SSB, 20hz in CW), RIT/XIT and filters can be toggled with the mouse
N1MM works great with FT rigs. Using it with my MKV. Great for contesting but not so hot for general logging. The band maps are awesome! Love the auto propagation from the Telnet/Packet spots to the
G'day Mike, Many thanks for your reply. According to the FT990 manual the data bytes have the following functions: data1 1/0=TX Clar On/Off, 81h/80h=RX Clar On/Off, ffh=clear offset data2 0=tune up,
G'day Jim, I've the documentation for FT1000 CAT protocol before me which is essentially identical to the FT990 with the exception that it has extra commands for dual band mode. You should be able to
Hi Mike, ok, I now see what you meant. Besides this, I've tried various combinations without success. I've downloaded the n1mm logger that also implements a radio interface for ft990/ft1000 but I cou
Hi Mike, I finally found a way to program the clarifier offset via the CAT interface. There were a few issues that caused the problem described in my previous email. 1.) data1 byte needs to be set to