Mail Archive Search: <+from:N4NT@bigfoot.com>

Results:

References: [ +from:N4NT@bigfoot.com: 21 ]

Total 21 documents matching your query.

1. [TenTec] Fw: 252 Power Supply Caution (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Sat, 4 Apr 1998 11:35:46 -0500; -- FAQ on WWW: http://www.contesting.com/tentecfaq.htm Submissions: tentec@contesting.com Administrative requests: tentec-REQUEST@contesting.com Problems: owner-tentec@contesting.com Search: http://w; /archives//html/TenTec/1998-04/msg00014.html (7,460 bytes)
2. [TenTec] 226 Calibrator (or Marker) Needed (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Sun, 5 Apr 1998 10:27:49 -0400; I need to buy or trade into a Ten-Tec model 226 Crystal Calibrator (also known as a frequency "marker") as used internally in both the Argosy 525 and Century 22. I have a model 276 calibrator for the; /archives//html/TenTec/1998-04/msg00021.html (7,155 bytes)
3. [TenTec] Tuning knob adj. (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 9 Apr 1998 08:03:58 -0400; Mornin' all. About PTO rebuilding, friend of mine advises the red grease supplied by Ten-Tec tends to get gummy with time. Ten-Tec gets it "down at the Co-op," I believe. Friend suggested using a hig; /archives//html/TenTec/1998-04/msg00063.html (8,819 bytes)
4. [TenTec] PTO Grease (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Fri, 10 Apr 1998 07:39:43 -0400; Hi Tom, I was trying to be helpful -- were you? I had PTO's rebuilt at the factory on my Omni-C, Triton 544, and Argosy II, then put them in storage for 5 years. When I took them out of storage, all; /archives//html/TenTec/1998-04/msg00079.html (7,428 bytes)
5. [TenTec] URL needed (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Tue, 14 Apr 1998 07:41:47 -0400; http://asd.state.va.us/tentec 73, Mike Hyder N4NT@bigfoot.com --Original Message-- -- FAQ on WWW: http://www.contesting.com/tentecfaq.htm Submissions: tentec@contesting.com Administrative requests: t; /archives//html/TenTec/1998-04/msg00116.html (7,728 bytes)
6. [TenTec] WTB: 500 Hz CW Filter # 217 (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Wed, 15 Apr 1998 20:25:18 -0400; Need a model 217 filter (the 500 Hz CW filter) which fits the old Omni series (and probably most of the newer rigs, too. The filter is an 8 pole model centered on 9.000750 MHz. Ten-Tec's stock number; /archives//html/TenTec/1998-04/msg00135.html (6,976 bytes)
7. [TenTec] PTO Grease Saga Continues (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Sun, 19 Apr 1998 12:27:29 -0400; Just cooked my Argosy II on a steam radiator. It got hot, but I never let it get too hot to touch. Ran dial from one end to other maybe 50 times with rig upside down, right side up, knobs down, knobs; /archives//html/TenTec/1998-04/msg00183.html (7,584 bytes)
8. [TenTec] PTO tunes itself (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Sun, 19 Apr 1998 13:17:23 -0400; How. Old Indian trick: Take felts out and turn former outer faces inward so they now touch each other. This puts fresh felt surfaces against the knob and dial skirt. Mike Hyder N4NT@bigfoot.com --Ori; /archives//html/TenTec/1998-04/msg00185.html (8,163 bytes)
9. Fw: [TenTec] Baked Triton (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Sun, 19 Apr 1998 15:26:44 -0400; Mike Hyder N4NT@bigfoot.com --Original Message-- From: Michael O. Hyder <N4NT@bigfoot.com> To: Steve Ellington <n4lq@iglou.com> To: <tentec@contesting.com> Date: Sunday, April 19, 1998 3:25 PM Subjec; /archives//html/TenTec/1998-04/msg00189.html (8,007 bytes)
10. [TenTec] Problems with OmniD (mod B) (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Mon, 20 Apr 1998 08:41:09 -0400; I am assuming you have checked any and all coax jumpers in your shack from antenna switches to tuners, etc. Then check antenna output connector on Omni. Don't mean to treat you like a dunce, and am s; /archives//html/TenTec/1998-04/msg00195.html (9,382 bytes)
11. [TenTec] Omni-C Noise Blanker Switch (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Mon, 20 Apr 1998 22:01:38 -0400; Is the switch turned on when pulled out or pushed in? Regards, Mike N4NT@bigfoot.com == Michael O. Hyder 401 E Holston Ave Johnson City TN 37601-4009 (423) 232-6453 == -- FAQ on WWW: http://www.conte; /archives//html/TenTec/1998-04/msg00202.html (6,790 bytes)
12. [TenTec] Argosy AGC and Low Power on One Band (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Wed, 22 Apr 1998 09:16:09 -0400; FIRST: Thanks to the folks at Ten-Tec for ALWAYS being helpful and friendly! ! Roses to you people in Sevierville. I have an Argosy Serial 525-00891 and an Argosy II Serial 525-01895. I do not yet ha; /archives//html/TenTec/1998-04/msg00221.html (8,373 bytes)
13. [TenTec] Low power amplifier kit (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 23 Apr 1998 10:55:22 -0400; this is mainly for Steve. Think of that Palomar amplifier as just one part in a kit. The bandpass filters can be obtained from a Ten-Tec junker as the other part. You would also need a knob and a sha; /archives//html/TenTec/1998-04/msg00239.html (7,558 bytes)
14. [TenTec] Correction to Low Power Amplifiers (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 23 Apr 1998 10:58:51 -0400; make that "low-pass filters" 73, N4NT@bigfoot.com -- FAQ on WWW: http://www.contesting.com/tentecfaq.htm Submissions: tentec@contesting.com Administrative requests: tentec-REQUEST@contesting.com Prob; /archives//html/TenTec/1998-04/msg00240.html (6,673 bytes)
15. [TenTec] QRO, QRP and Courtesy (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 23 Apr 1998 12:08:40 -0400; QRO means, "please increase your power." QRP means, "please decrease your power." We believe ourselves to be gentlemen (and ladies). If a person said to me, "I am hard of hearing, could you speak up?; /archives//html/TenTec/1998-04/msg00245.html (9,133 bytes)
16. Fw: [TenTec] QRO, QRP and Courtesy (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 23 Apr 1998 13:04:25 -0400; me -- FAQ on WWW: http://www.contesting.com/tentecfaq.htm Submissions: tentec@contesting.com Administrative requests: tentec-REQUEST@contesting.com Problems: owner-tentec@contesting.com Search: http:; /archives//html/TenTec/1998-04/msg00251.html (9,158 bytes)
17. [TenTec] To Answer or Not to Answer, that is the Question (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 23 Apr 1998 13:36:18 -0400; Allen wants me to answer his down in the mud signal so he can work Tennessee on QRP. Jack implies that if I answer, I am saying I am willing to ragchew and if I am not, then I should not answer. I fe; /archives//html/TenTec/1998-04/msg00255.html (8,128 bytes)
18. [TenTec] Fw: Undeliverable Mail (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 23 Apr 1998 19:31:49 -0400; Colonel, here's your reply through the reflector -- the original got bogged down in army red tape. 73, Mike N4NT@bigfoot.com To: <tentec@contesting.com> -- FAQ on WWW: http://www.contesting.com/tente; /archives//html/TenTec/1998-04/msg00265.html (8,334 bytes)
19. [TenTec] Re: Electric Fence Noise (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Sat, 25 Apr 1998 12:07:09 -0400; Had a similar problem with electric fence. Owner let me examine the installation. Fence charger was one which had a powerful surge available to knock down weeds. When we walked the perimeter of the N; /archives//html/TenTec/1998-04/msg00289.html (7,056 bytes)
20. [TenTec] Argosy 525 calibrator wanted (score: 1): Author: N4NT@bigfoot.com (Michael O. Hyder); Date: Thu, 26 Mar 1998 21:14:50 -0500; Hi. I need a crystal calibrator for an Argosy 525. Thanks, Mike -N4NT- -- FAQ on WWW: http://www.contesting.com/tentecfaq.htm Submissions: tentec@contesting.com Administrative requests: tentec-REQUES; /archives//html/TenTec/1998-03/msg00241.html (6,638 bytes)

Current List: 1 - 20
Page: [1] [2]