Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+TenTec\s+425\s+Plate\s+Current\s+at\s+Standby\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Amps\]\s+TenTec\s+425\s+Plate\s+Current\s+at\s+Standby\s*$/: 5 ]

Total 5 documents matching your query.

1. [Amps] TenTec 425 Plate Current at Standby (score: 1): Author: Robert Paluf <robert_paluf@hotmail.com>; Date: Fri, 3 Feb 2017 18:27:09 +0000; Dear Gentlemen, I have been copying the mail on all of the discussions about amplifiers for a long time. I am now the new owner of an older TenTec Titan HF amplifier, model 425. I picked it up from a; /archives//html/Amps/2017-02/msg00006.html (11,379 bytes)
2. Re: [Amps] TenTec 425 Plate Current at Standby (score: 1): Author: Jim Brown <jim@audiosystemsgroup.com>; Date: Fri, 3 Feb 2017 11:20:00 -0800; These are very nice amps. I own three of them -- two in my SO2R contesting station and the third a standby. Two of the amps came to me with problems that I had to fix. The schematics in the manual ar; /archives//html/Amps/2017-02/msg00008.html (8,234 bytes)
3. Re: [Amps] TenTec 425 Plate Current at Standby (score: 1): Author: Joe via Amps <amps@contesting.com>; Date: Sat, 4 Feb 2017 11:03:44 -0500; While I sold my two 425s some time ago, I believe that this is a common problem when the amp is over-driven. R17 on the bias board opens up. It is a 4.7 ohm, 5% resistor and is accessible by removing; /archives//html/Amps/2017-02/msg00010.html (13,088 bytes)
4. Re: [Amps] TenTec 425 Plate Current at Standby (score: 1): Author: Mark Robinson <markrob@mindspring.com>; Date: Sat, 4 Feb 2017 16:07:48 -0500; I have a Tentec 425 as well (Golden Series) and I love this amplifier. I have had this plate current problem twice in the last two years and both times it was a bad Chinese Matchlett tube. I hope it; /archives//html/Amps/2017-02/msg00012.html (9,580 bytes)
5. Re: [Amps] TenTec 425 Plate Current at Standby (score: 1): Author: Steve Bookout <steve@nr4m.com>; Date: Mon, 6 Feb 2017 17:49:59 -0500; Hello all, This is spooky-weird. I have been following this thread from the beginning only because I am the original owner of a 425 amp. Just general interest. A few days ago, I started trouble shoot; /archives//html/Amps/2017-02/msg00013.html (9,271 bytes)

Current List: 1 - 5
Page: [1]