Has anyone had any luck running the AP1000 in 802.11b mode with non-lucent cards. I'm hoping to find a 100mw solution, but it has to be 802.11b mode NOT Turbocell. Does the Karlnet SEC Base software
The higher output radios don't work in the AP-1000. The hardware isn't setup to handle the power. Doug Harman KarlNet, Inc. 525 Metro Place North Suite 100 Dublin, OH 43017 614 822-5275 x 123 614 822
Hmm... I could have sworn that there were a few guys that had the AP-1000's running in Turbocell mode with the prism cards. Here is what I need: Some sort of hardware suitable for tower mounting (lig
Larry Your request is for SEC which is not an option under the prism cards, SEC only works for Orinoco cards. Sincerely Tony Morella Demarc Technology Group Office: 908-996-7995 Cell: 908-246-9170 Fa
So you are stating that you can't even run 100mw cards in SEC mode in a PC running a karlnet flash-rom kit? This sounds worse than I had thought. I was really hoping to stay with Karlnet for it's nic
Larry This is correct at this time, I have not received a update on whether or not SEC will be supported on the Prism chip. Doug any comments on this?? Sincerely Tony Morella Demarc Technology Group
Doug, I thought you stated that the prism 2.5 cards do work (100mw and 200mw) Dan Metcalf Wireless Broadband Sytems dan.metcalf@wbsysnet.com www.wirelessbroadbandsystems.com On isn't [mailto:karlnet-
Tony, Can we clarify what DOUG said? I thought he said the prism 2.0 cards DO NOT work and the PRISM 2.5 cards do work (100 & 200mw)? Dan Metcalf Wireless Broadband Sytems dan.metcalf@wbsysnet.com ww
Dan Unless he as a new version none of the Prism 2.0 or 2.5 cards we have work in SEC mode. I think his comment where talking at TC mode and the power issues. Sincerely Tony Morella Demarc Technology
I'm checking on the SEC support. I've talked with Doug Karl, since he had to do some things with SEC that weren't supported in the Prism firmware. He thinks that they wouldn't work in bridging mode,
Let me know what you find out. It will take some reconfiguration of our network, but I could use the SEC with routing rather than bridging if it would support the higher powered cards.
Doug FYI we tested this :) When the cards are in SEC mode with just routing turned on the unit locks up on the cards port. Sincerely Tony Morella Demarc Technology Group Office: 908-996-7995 Cell: 90