Let me know what you find out. It will take some reconfiguration of our
network, but I could use the SEC with routing rather than bridging if it would
support the higher powered cards.
---------- Original Message ----------------------------------
From: "Support" <support@karlnet.com>
Reply-To: karlnet@WISPNotes.com
Date: Mon, 24 Jun 2002 16:58:05 -0400
>I'm checking on the SEC support. I've talked with Doug Karl, since he had
>to do some things with SEC that weren't supported in the Prism firmware. He
>thinks that they wouldn't work in bridging mode, but should work in NAT or
>Routing mode. I'm going to have our guys take a closer look at the radios
>and can give everyone a better answer then.
>
>I will be at WCA tomorrow and Weds with Kevin Knuth. Look forward to seeing
>some of you in Boston.
>
>Doug Harman
>KarlNet, Inc.
>525 Metro Place North
>Suite 100
>Dublin, OH 43017
>614 822-5275 x 123
>614 822-0024 fax
>
>> -----Original Message-----
>> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
>> Behalf Of Tony
>> Sent: Saturday, June 22, 2002 11:39 AM
>> To: karlnet@WISPNotes.com
>> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>>
>>
>> Larry
>>
>> This is correct at this time, I have not received a update on whether or
>> not SEC will be supported on the Prism chip. Doug any comments on
>> this??
>>
>> Sincerely
>> Tony Morella
>> Demarc Technology Group
>> Office: 908-996-7995
>> Cell: 908-246-9170
>> Fax: 908-847-0202
>> email: tony@demarctech.com
>> http://www.demarctech.com
>> Wireless Solution Provider
>>
>>
>> -----Original Message-----
>> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
>> On Behalf Of Larry Yunker
>> Sent: Friday, June 21, 2002 9:24 PM
>> To: karlnet@WISPNotes.com
>> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>>
>>
>> So you are stating that you can't even run 100mw cards in SEC mode in a
>> PC running a karlnet flash-rom kit? This sounds worse than I had
>> thought. I was really hoping to stay with Karlnet for it's nice client
>> signal monitoring capability. But I really need to get cards with more
>> juice than 35mw and I really DON'T want to resort to AMPs.
>>
>>
>> ---------- Original Message ----------------------------------
>> From: "Tony " <tonylist@wwwbiz.com>
>> Reply-To: karlnet@WISPNotes.com
>> Date: Fri, 21 Jun 2002 20:06:08 -0400
>>
>> >Larry
>> >
>> >Your request is for SEC which is not an option under the prism cards,
>> >SEC only works for Orinoco cards.
>> >
>> >Sincerely
>> >Tony Morella
>> >Demarc Technology Group
>> >Office: 908-996-7995
>> >Cell: 908-246-9170
>> >Fax: 908-847-0202
>> >email: tony@demarctech.com
>> >http://www.demarctech.com
>> >Wireless Solution Provider
>> >
>> >
>> >-----Original Message-----
>> >From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
>> >On Behalf Of Larry Yunker
>> >Sent: Friday, June 21, 2002 4:33 PM
>> >To: karlnet@WISPNotes.com
>> >Subject: RE: [Karlnet] AP1000 with non-lucent cards
>> >
>> >
>> >Hmm... I could have sworn that there were a few guys that had the
>> >AP-1000's running in Turbocell mode with the prism cards.
>> >
>> >Here is what I need:
>> >
>> >Some sort of hardware suitable for tower mounting (lightweight, weather
>>
>> >resistant, Power-over-ethernet, etc, etc)
>> >
>> >Karlnet SEC BASE
>> >three 100mw Cards (to run 3 sector antennas)
>> >one standard 35mw Lucent Silver/Gold Card (to run backhaul to NOC
>> >cross-polarized and 25ft vertical separation from the sectors)
>> >
>> >Does anyone market a 4-PCMCIA-slot SBC's with Karlnet firmware? Or
>> >maybe I'll just need to get two 2-PCMCIA slot SBC's with Karlnet.
>> >
>> >Anyway... if Karlnet has any suggestions or if any vendors would like
>> >to contact me off-list, I'm looking for a solution!
>> >
>> >Thanks,
>> >Larry
>> >
>> >
>> >---------- Original Message ----------------------------------
>> >From: "Support" <support@karlnet.com>
>> >Reply-To: karlnet@WISPNotes.com
>> >Date: Fri, 21 Jun 2002 15:47:59 -0400
>> >
>> >>The higher output radios don't work in the AP-1000. The hardware
>> >>isn't
>> >
>> >>setup to handle the power.
>> >>
>> >>Doug Harman
>> >>KarlNet, Inc.
>> >>525 Metro Place North
>> >>Suite 100
>> >>Dublin, OH 43017
>> >>614 822-5275 x 123
>> >>614 822-0024 fax
>> >>
>> >>> -----Original Message-----
>> >>> From: karlnet-admin@WISPNotes.com
>> >>> [mailto:karlnet-admin@WISPNotes.com]On
>> >>> Behalf Of Larry Yunker
>> >>> Sent: Friday, June 21, 2002 11:25 AM
>> >>> To: karlnet@WISPNotes.com
>> >>> Subject: [Karlnet] AP1000 with non-lucent cards
>> >>>
>> >>>
>> >>> Has anyone had any luck running the AP1000 in 802.11b mode with
>> >>> non-lucent cards. I'm hoping to find a 100mw solution, but it has
>> to
>> >
>> >>> be 802.11b mode NOT Turbocell.
>> >>>
>> >>> Does the Karlnet SEC Base software let me do this?
>> >>>
>> >>>
>> >>> _______________________________________________
>> >>> Karlnet mailing list
>> >>> Karlnet@WISPNotes.com
>> >>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>> >>>
>> >>
>> >>_______________________________________________
>> >>Karlnet mailing list
>> >>Karlnet@WISPNotes.com
>> >>http://lists.wispnotes.com/mailman/listinfo/karlnet
>> >>
>> >_______________________________________________
>> >Karlnet mailing list
>> >Karlnet@WISPNotes.com
>> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>> >
>> >_______________________________________________
>> >Karlnet mailing list
>> >Karlnet@WISPNotes.com
>> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>> >
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|