Karlnet
[Top] [All Lists]

RE: [Karlnet] 100 mW PRISM 2.5 cards do not report signal or noise w/TC.

To: <karlnet@WISPNotes.com>
Subject: RE: [Karlnet] 100 mW PRISM 2.5 cards do not report signal or noise w/TC...
From: "Kevin Knuth" <kknuth@karlnet.com>
Reply-to: karlnet@WISPNotes.com
Date: Sun, 23 Jun 2002 08:21:04 -0500
List-post: <mailto:karlnet@WISPNotes.com>
I can chime in here with 99% accuracy!

This is a FIRMWARE issue, not a TurboCell issue.

The card manufacturer needs to make changes to their firmware for this type
of information to be available.

Kevin

-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Norm Young
Sent: Sunday, June 23, 2002 7:48 AM
To: karlnet@WISPNotes.com
Cc: support@karlnet.com
Subject: Re: [Karlnet] 100 mW PRISM 2.5 cards do not report signal or
noise w/TC...


Ok, but with one clarification, _both_ signal and noise are not reported
correctly.  It would be very nice if TC could read the card, or a firmware
fix could make it so.  Do you know the status of other PRISM 2.5 card as to
this reporting problem, ie; the Mikrotik 250mW cards?   Do they report the
signal/noise levels correctly to TC?   If so, then it's a matter of getting
the card manufacturer's firmware to adhere to this standard.   I wonder if
Doug could chime in here to confirm that this is a firmware problem with the
card?   Does Karlnet have a fix for this card?

Norm


----- Original Message -----
From: "Tony " <tonylist@wwwbiz.com>
To: <karlnet@WISPNotes.com>
Sent: Saturday, June 22, 2002 9:24 PM
Subject: RE: [Karlnet] 100 mW PRISM card do not report signal or noise
w/TC...


> Norm
>
> This is correct, I believe Doug posted this is other day.  TC does not
> report noise level as the firmware on all Prism cards do not report it
> yet.  From what I have been told the card can do it if the firmware is
> change seems like a simple request, still looking into this.
>
> In the mean time we put in a request to grey out the s/n and noise
> readings as not to confuse things.
>
> Sincerely
> Tony Morella
> Demarc Technology Group
> Office: 908-996-7995
> Cell: 908-246-9170
> Fax: 908-847-0202
> email: tony@demarctech.com
> http://www.demarctech.com
> Wireless Solution Provider
>
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> On Behalf Of Norm Young
> Sent: Saturday, June 22, 2002 11:45 PM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] 100 mW PRISM card do not report signal or noise
> w/TC...
>
>
> Tony, I tried your 100mW PRISM 2.5 cards in TC v4.02/AP-1000/SA-4400,
> and while the signal gains at the CPE's were impressive (7-8dB reported
> from the CPE Orinoco radio on average), the reporting from the PRISM 2.5
> card was, well, non-existent.  All of my CPEs are reported to have a S/N
> of 1, signal -94, noise, -95.  Obviously bogus, obviously not reported
> correctly by the card, or correctly interpreted by Karlnet TC.
>
> Norm
>
>
> ----- Original Message -----
> From: "Tony " <tonylist@wwwbiz.com>
> To: <karlnet@WISPNotes.com>
> Sent: Saturday, June 22, 2002 8:38 AM
> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>
>
> > Larry
> >
> > This is correct at this time, I have not received a update on whether
> > or not SEC will be supported on the Prism chip.  Doug any comments on
> > this??
> >
> > Sincerely
> > Tony Morella
> > Demarc Technology Group
> > Office: 908-996-7995
> > Cell: 908-246-9170
> > Fax: 908-847-0202
> > email: tony@demarctech.com
> > http://www.demarctech.com
> > Wireless Solution Provider
> >
> >
> > -----Original Message-----
> > From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> > On Behalf Of Larry Yunker
> > Sent: Friday, June 21, 2002 9:24 PM
> > To: karlnet@WISPNotes.com
> > Subject: RE: [Karlnet] AP1000 with non-lucent cards
> >
> >
> > So you are stating that you can't even run 100mw cards in SEC mode in
> > a PC running a karlnet flash-rom kit?  This sounds worse than I had
> > thought.  I was really hoping to stay with Karlnet for it's nice
> > client signal monitoring capability.  But I really need to get cards
> > with more juice than 35mw and I really DON'T want to resort to AMPs.
> >
> >
> > ---------- Original Message ----------------------------------
> > From: "Tony " <tonylist@wwwbiz.com>
> > Reply-To: karlnet@WISPNotes.com
> > Date: Fri, 21 Jun 2002 20:06:08 -0400
> >
> > >Larry
> > >
> > >Your request is for SEC which is not an option under the prism cards,
>
> > >SEC only works for Orinoco cards.
> > >
> > >Sincerely
> > >Tony Morella
> > >Demarc Technology Group
> > >Office: 908-996-7995
> > >Cell: 908-246-9170
> > >Fax: 908-847-0202
> > >email: tony@demarctech.com
> > >http://www.demarctech.com
> > >Wireless Solution Provider
> > >
> > >
> > >-----Original Message-----
> > >From: karlnet-admin@WISPNotes.com
> > >[mailto:karlnet-admin@WISPNotes.com]
> > >On Behalf Of Larry Yunker
> > >Sent: Friday, June 21, 2002 4:33 PM
> > >To: karlnet@WISPNotes.com
> > >Subject: RE: [Karlnet] AP1000 with non-lucent cards
> > >
> > >
> > >Hmm... I could have sworn that there were a few guys that had the
> > >AP-1000's running in Turbocell mode with the prism cards.
> > >
> > >Here is what I need:
> > >
> > >Some sort of hardware suitable for tower mounting (lightweight,
> > >weather
> >
> > >resistant, Power-over-ethernet, etc, etc)
> > >
> > >Karlnet SEC BASE
> > >three 100mw Cards (to run 3 sector antennas)
> > >one standard 35mw Lucent Silver/Gold Card (to run backhaul to NOC
> > >cross-polarized and 25ft vertical separation from the sectors)
> > >
> > >Does anyone market a 4-PCMCIA-slot SBC's with Karlnet firmware?  Or
> > >maybe I'll just need to get two 2-PCMCIA slot SBC's with Karlnet.
> > >
> > >Anyway... if Karlnet has any suggestions or if any vendors would like
>
> > >to contact me off-list, I'm looking for a solution!
> > >
> > >Thanks,
> > >Larry
> > >
> > >
> > >---------- Original Message ----------------------------------
> > >From: "Support" <support@karlnet.com>
> > >Reply-To: karlnet@WISPNotes.com
> > >Date: Fri, 21 Jun 2002 15:47:59 -0400
> > >
> > >>The higher output radios don't work in the AP-1000.  The hardware
> > >>isn't
> > >
> > >>setup to handle the power.
> > >>
> > >>Doug Harman
> > >>KarlNet, Inc.
> > >>525 Metro Place North
> > >>Suite 100
> > >>Dublin, OH 43017
> > >>614 822-5275 x 123
> > >>614 822-0024 fax
> > >>
> > >>> -----Original Message-----
> > >>> From: karlnet-admin@WISPNotes.com
> > >>> [mailto:karlnet-admin@WISPNotes.com]On
> > >>> Behalf Of Larry Yunker
> > >>> Sent: Friday, June 21, 2002 11:25 AM
> > >>> To: karlnet@WISPNotes.com
> > >>> Subject: [Karlnet] AP1000 with non-lucent cards
> > >>>
> > >>>
> > >>> Has anyone had any luck running the AP1000 in 802.11b mode with
> > >>> non-lucent cards.  I'm hoping to find a 100mw solution, but it has
> > to
> > >
> > >>> be 802.11b mode NOT Turbocell.
> > >>>
> > >>> Does the Karlnet SEC Base software let me do this?
> > >>>
> > >>>
> > >>> _______________________________________________
> > >>> Karlnet mailing list
> > >>> Karlnet@WISPNotes.com
> > >>> http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >>>
> > >>
> > >>_______________________________________________
> > >>Karlnet mailing list
> > >>Karlnet@WISPNotes.com
> > >>http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >>
> > >_______________________________________________
> > >Karlnet mailing list
> > >Karlnet@WISPNotes.com
> > >http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >
> > >_______________________________________________
> > >Karlnet mailing list
> > >Karlnet@WISPNotes.com
> > >http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet


<Prev in Thread] Current Thread [Next in Thread>