Larry
This is correct at this time, I have not received a update on whether or
not SEC will be supported on the Prism chip. Doug any comments on
this??
Sincerely
Tony Morella
Demarc Technology Group
Office: 908-996-7995
Cell: 908-246-9170
Fax: 908-847-0202
email: tony@demarctech.com
http://www.demarctech.com
Wireless Solution Provider
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On Behalf Of Larry Yunker
Sent: Friday, June 21, 2002 9:24 PM
To: karlnet@WISPNotes.com
Subject: RE: [Karlnet] AP1000 with non-lucent cards
So you are stating that you can't even run 100mw cards in SEC mode in a
PC running a karlnet flash-rom kit? This sounds worse than I had
thought. I was really hoping to stay with Karlnet for it's nice client
signal monitoring capability. But I really need to get cards with more
juice than 35mw and I really DON'T want to resort to AMPs.
---------- Original Message ----------------------------------
From: "Tony " <tonylist@wwwbiz.com>
Reply-To: karlnet@WISPNotes.com
Date: Fri, 21 Jun 2002 20:06:08 -0400
>Larry
>
>Your request is for SEC which is not an option under the prism cards,
>SEC only works for Orinoco cards.
>
>Sincerely
>Tony Morella
>Demarc Technology Group
>Office: 908-996-7995
>Cell: 908-246-9170
>Fax: 908-847-0202
>email: tony@demarctech.com
>http://www.demarctech.com
>Wireless Solution Provider
>
>
>-----Original Message-----
>From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
>On Behalf Of Larry Yunker
>Sent: Friday, June 21, 2002 4:33 PM
>To: karlnet@WISPNotes.com
>Subject: RE: [Karlnet] AP1000 with non-lucent cards
>
>
>Hmm... I could have sworn that there were a few guys that had the
>AP-1000's running in Turbocell mode with the prism cards.
>
>Here is what I need:
>
>Some sort of hardware suitable for tower mounting (lightweight, weather
>resistant, Power-over-ethernet, etc, etc)
>
>Karlnet SEC BASE
>three 100mw Cards (to run 3 sector antennas)
>one standard 35mw Lucent Silver/Gold Card (to run backhaul to NOC
>cross-polarized and 25ft vertical separation from the sectors)
>
>Does anyone market a 4-PCMCIA-slot SBC's with Karlnet firmware? Or
>maybe I'll just need to get two 2-PCMCIA slot SBC's with Karlnet.
>
>Anyway... if Karlnet has any suggestions or if any vendors would like
>to contact me off-list, I'm looking for a solution!
>
>Thanks,
>Larry
>
>
>---------- Original Message ----------------------------------
>From: "Support" <support@karlnet.com>
>Reply-To: karlnet@WISPNotes.com
>Date: Fri, 21 Jun 2002 15:47:59 -0400
>
>>The higher output radios don't work in the AP-1000. The hardware
>>isn't
>
>>setup to handle the power.
>>
>>Doug Harman
>>KarlNet, Inc.
>>525 Metro Place North
>>Suite 100
>>Dublin, OH 43017
>>614 822-5275 x 123
>>614 822-0024 fax
>>
>>> -----Original Message-----
>>> From: karlnet-admin@WISPNotes.com
>>> [mailto:karlnet-admin@WISPNotes.com]On
>>> Behalf Of Larry Yunker
>>> Sent: Friday, June 21, 2002 11:25 AM
>>> To: karlnet@WISPNotes.com
>>> Subject: [Karlnet] AP1000 with non-lucent cards
>>>
>>>
>>> Has anyone had any luck running the AP1000 in 802.11b mode with
>>> non-lucent cards. I'm hoping to find a 100mw solution, but it has
to
>
>>> be 802.11b mode NOT Turbocell.
>>>
>>> Does the Karlnet SEC Base software let me do this?
>>>
>>>
>>> _______________________________________________
>>> Karlnet mailing list
>>> Karlnet@WISPNotes.com
>>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>>
>>
>>_______________________________________________
>>Karlnet mailing list
>>Karlnet@WISPNotes.com
>>http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|