Tony,
Can we clarify what DOUG said? I thought he said the prism 2.0 cards DO
NOT work and the PRISM 2.5 cards do work (100 & 200mw)?
Dan Metcalf
Wireless Broadband Sytems
dan.metcalf@wbsysnet.com
www.wirelessbroadbandsystems.com
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On
> Behalf Of Tony
> Sent: Friday, June 21, 2002 8:06 PM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>
> Larry
>
> Your request is for SEC which is not an option under the prism cards,
> SEC only works for Orinoco cards.
>
> Sincerely
> Tony Morella
> Demarc Technology Group
> Office: 908-996-7995
> Cell: 908-246-9170
> Fax: 908-847-0202
> email: tony@demarctech.com
> http://www.demarctech.com
> Wireless Solution Provider
>
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> On Behalf Of Larry Yunker
> Sent: Friday, June 21, 2002 4:33 PM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>
>
> Hmm... I could have sworn that there were a few guys that had the
> AP-1000's running in Turbocell mode with the prism cards.
>
> Here is what I need:
>
> Some sort of hardware suitable for tower mounting (lightweight,
weather
> resistant, Power-over-ethernet, etc, etc)
>
> Karlnet SEC BASE
> three 100mw Cards (to run 3 sector antennas)
> one standard 35mw Lucent Silver/Gold Card (to run backhaul to NOC
> cross-polarized and 25ft vertical separation from the sectors)
>
> Does anyone market a 4-PCMCIA-slot SBC's with Karlnet firmware? Or
> maybe I'll just need to get two 2-PCMCIA slot SBC's with Karlnet.
>
> Anyway... if Karlnet has any suggestions or if any vendors would like
to
> contact me off-list, I'm looking for a solution!
>
> Thanks,
> Larry
>
>
> ---------- Original Message ----------------------------------
> From: "Support" <support@karlnet.com>
> Reply-To: karlnet@WISPNotes.com
> Date: Fri, 21 Jun 2002 15:47:59 -0400
>
> >The higher output radios don't work in the AP-1000. The hardware
isn't
>
> >setup to handle the power.
> >
> >Doug Harman
> >KarlNet, Inc.
> >525 Metro Place North
> >Suite 100
> >Dublin, OH 43017
> >614 822-5275 x 123
> >614 822-0024 fax
> >
> >> -----Original Message-----
> >> From: karlnet-admin@WISPNotes.com
> >> [mailto:karlnet-admin@WISPNotes.com]On
> >> Behalf Of Larry Yunker
> >> Sent: Friday, June 21, 2002 11:25 AM
> >> To: karlnet@WISPNotes.com
> >> Subject: [Karlnet] AP1000 with non-lucent cards
> >>
> >>
> >> Has anyone had any luck running the AP1000 in 802.11b mode with
> >> non-lucent cards. I'm hoping to find a 100mw solution, but it has
to
>
> >> be 802.11b mode NOT Turbocell.
> >>
> >> Does the Karlnet SEC Base software let me do this?
> >>
> >>
> >> _______________________________________________
> >> Karlnet mailing list
> >> Karlnet@WISPNotes.com
> >> http://lists.wispnotes.com/mailman/listinfo/karlnet
> >>
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]
>
---
[This E-mail scanned for viruses by Declude Virus]
|