Hello, decided to go with a HAL. Been looking over the manuals for each piece of equipment and not quite clear on the hookup. This is what I have come up with: FSK jack on Hal to RTTY jack on TS850 w
OUT I hate that 13 pin din on the 850. The male connector is hard to find, the pins are close together, and it is susceptible to rfi. I take the audio off the speaker output. Yes, you have to pay att
I noticed that the www.buxcomm.com website has available a ready-made (one-end) 13 pin DIN cable to make things a little easier... 73, Kevin <><><><><><><><><><><><><><> Amateur Radio Station - KD1J
Check the connections very carefully before you order. (wiring diagram). The Kenwood cables don't support FSK as advertised. Tom, W1TO each AF in _______________________________________________ RTTY
Tom, I do not know if this is a correct statement or not? The prewired 13 pin cable is $5.95 and has all 13 pin wired. As for the cable that go with the Rascal, for the newer Kenwoods, TS-2000, TS-87
The cables on the web site don't support the 870, at least one iteration. My buddy just ordered one and it doesn't work. He needs the RCA cable to the rig. Bux used to have such a cable on their web
Tom you are correct, Buck doesn't show the cable for the TS-850/870 that needs the RCA and he used to. The question was about the prewired 13 pin cable. If you look at: http://www.k4abt.com/psk31part
_________________________________________________________ I know this doesn't answer you question directly, but you'd be better off to ditch the HAL and download MMTTY. I've compared the two side by