I only see a couple of entries in the eHam reviews for the Inrad roofing filters for the Omni VI. I'm considering getting the CW version and would appreciate any comments on the performance enhanceme
Paul, K5AF asked : I only see a couple of entries in the eHam reviews for the Inrad roofing filters for the Omni VI. I'm considering getting the CW version and would appreciate any comments on the pe
Subject to what Terry said from his QTH - I find the 600 Hz (lower center freq.) roofing filter to be very helpful in heavy QRM and noise situations for my ears. It helps the audio DSP to engage bett
Clark, appreciate hearing you results, do you engage it with just N1 or N2 or with both? Currently just have a 500 in the N2 slot, 90 percent of my operating is weak signal, usually low band 160/80 a
Merv - only one of the first IF filters can be engaged at a time - N1 or N2 - not both. (Maybe that isn't what you were asking...) 73, Duane _______________________________________________ TenTec mai
Like Duane said, you can't hit both N1 and N2 (but I think you can set the roofing filter to engage with only one of these if you wish?) I have it set to engage whenever I press N1 or N2 (and I have
Paul, I have installed the two 400Hz Inrad filters (#750/#759), in addition to the 600Hz roofing filter (#763) and board. I can tell you from my perspective, after replacing the TT 2x500 and 2x250 fi
Bill: Just wondering where Inrad could be convinced to build a small run of filtres if a certain number of folks were to order at the same price, and pay in advance, etc.? Whatsay? Might well be wort
Paul, I have a brand new InRad 600 Hz CW roofing filter for the Omni_VI I will sell you for 80% of the price of a new one. I decided not to put it in my Onmi-VI as I probably would not do a good job,
I wired our club's Omni6+ so that the CW roofing filter is activated by the Processor button, (but only when CW mode is selected). Therefore all filter selctions remain possible. I'll dig out the inf
Some info about the Inrad roofing filter mod as well as K1FK's instructions for using the PROC button to activate the filter is located at http://www.tentecwiki.org/doku.php?id=563inrad . 73, Alan N5
Fraser:Per your post on the TEN TEC Arcives.I sure would be intrested in your modification method if it is not to much trouble.I have had my OMNI 6+ for over 7 years and ONLY OPERATE CW so the loss o
I'd like that ............ thanks. Walt K8CV Royal Oak, MI. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tent